Old Guy Bill's latest activity
-
+1 on all of the above. Confirming that bondo works on bare metal, primer or paint as well. There are considerations when not going to... -
Old Guy Bill reacted to Robert Bare's post in the thread 1999 454 carb swap. best street carb, 600? 650? 750? CFM with
Like.
What are your complaints? Anyway, best to stick with a square bore carb, adapters suck, generally. Bigest problems with slappin a carb... -
Yep...81 to 87. 4x4 or 2WD. The hump can be changed.
-
@hey mister cool to see you trying new stuff. Couple comments to your post. 1. Paint expense. You’re right, ain’t cheap. But you’ll pay...
-
Just going to warn people, be sure you only have friends around, no "bad" neighbors,or in an area where you have a hairbag "greenie"...
-
I miss my dad’s 68. I don’t miss the burns on the calf from forgetting the sidepipes were hot.
-
I was at the museum back in 2013. I believe it was Feb. the following year when the sinkhole opened up in there. What a mess, they did...
-
A long bar good for doing this is just a plain old piece of conduit. And if you have axles out you can run conduit from where 1 wheel...
-
I've always done one side at a time. All left. Then all right. That way you're tilting the body side to side and not putting too much...
-
Old Guy Bill replied to the thread Pure SEX!.The Corvette museum in Bowling Green, KY is a cool attraction, the wife and I’ve been to, we did the factory tour also. They raffle cars...
-
Old Guy Bill replied to the thread Rear body mounts for a 74 k20.First thing is loosen all four mounts, breaker bar or impact, either will work. Try not to twist any of the bolts off. Jack up one...
-
Old Guy Bill replied to the thread Pure SEX!.I had a ‘72 as a much younger man, I loved it and still do love that generation. A neighbor up the street has a red 69 sitting in the...
-
I think this came up before, but any of you fellas that are doing extensive rust or damage repair, and need a pic of a factory seam or...
-
Old Guy Bill reacted to bucket's post in the thread 3 on the tree to sm465 conversion questions with Like.
Correct. Cut the opening so that there is still a 3/4" to 1" flange to attach the new trans hump. You can simply use self tappers, or...
-
Well with months of searching I finally found my transfer case and now it's time to fab a cross member and lengthen and shorten driveshafts
