NickTransmissions's latest activity
-
NickTransmissions replied to the thread How many bolts hold the transmission on and where?.Then you don't have a flywheel, you have a flex plate...They are not the same nor can the terms be used interchangeably...Just FYI if... -
NickTransmissions replied to the thread How many bolts hold the transmission on and where?.Do you have an auto trans or a manual?
-
NickTransmissions replied to the thread How many bolts hold the transmission on and where?.Not really. It's much easier to simply remove the trans, get it out of the way so the flexplate can be removed and new one installed...
-
NickTransmissions replied to the thread Rebuild th400 or 4l80e?.Your new aluminum 2-3 acc piston is threaded? I've never encountered that before. It should have a smooth bore. You can use a press or...
-
NickTransmissions replied to the thread Th400 Torque Converter Shaft Seal.Since you will have the pump open, do the following checks: - Inspect the pump body working surface for scoring, unusual wear, etc -...
-
NickTransmissions reacted to perky's post in the thread Th400 Torque Converter Shaft Seal with
Like.
Read up on the bushing and figuring I'll replace it as long as the trans is out, because it seems to be a common source of leaks on... -
NickTransmissions replied to the thread Th400 Torque Converter Shaft Seal.You're welcome...I should clarify my above to say the pump would have to come out and apart so you can replace the bushing, if worn as...
-
NickTransmissions replied to the thread Th400 Torque Converter Shaft Seal.Check the pump bushing once you have the front seal off. If it's excessively worn, trans would have to come out so it can be replaced.
-
NickTransmissions replied to the thread 350turbo out 700r4 in expected cost?.2WD or 4X4? Also, are you doing the physical swap or outsourcing it? Figure $150-300 for a cut/balance of the driveline by a driveshaft...
-
NickTransmissions replied to the thread TH350 Plug Question in case.Nice, thanks @quicksilver702. Reach out to me off-line if you run into any problems with the build...Since we are in the same city (I'm...
-
NickTransmissions reacted to quicksilver702's post in the thread TH350 Plug Question in case with Like.
Sure thing!
-
NickTransmissions replied to the thread TH350 Plug Question in case.Nice...Please post some pics of the valve line ups and casting itself if you can (no rush)...Curious to see what was done...
-
NickTransmissions replied to the thread TH350 Plug Question in case.You should be able to either drill through it (be very careful if electing to do to this) or perhaps punch it out with a drift by...
-
NickTransmissions reacted to quicksilver702's post in the thread TH350 Plug Question in case with Like.
Yes, it has been heavily modified for manual shifting. There was no governor at all in there. The valve body has been extensively...
-
NickTransmissions replied to the thread TH350 Plug Question in case.Looks like someone may have modified that unit for manual shifting. What does the governor look like? Is the manual low control valve...
