Memaloose's latest activity
-
Memaloose replied to the thread Howdy from North Texas.Welcome from AZ too! -
North Coast checking in Pictures
-
Hello everyone from from Oregon and beyond our borders. My name is Jim and I am in the process of doing a frame off restoration of a...
-
Memaloose replied to the thread A grand hello From eastern Oregon.Welcome Jim from NW Arizona. Sounds like a very nice pickup you have. I'm assuming the 6.6L is a small block 400. I owned a '79...
-
I can't say for sure since my 76 is carbureted, but i have a 94 Camaro Z28 with what appears to be a similar plug. My plug is meant to...
-
It'll pep the engine a little. But don't expect a lot. Especially with a 2 barrel and low compression engine.If I had a 307 now,I'd put...
-
307s were nothing to write home about. They never made a 4bbl version, they didn't make a lot of power and the gas mileage was so so...
-
I suspected as much; the community I used to live in(and where my building still is) gets very anal about non moving or expired license...
-
Ace hardware
-
Man even NOS or stainless steel should be cheaper than that....1/4-20 threaded rod, usually comes in a foot long stick, just cut to measure.
-
You can also get bare 1/4 rod. Then just cut threads on each end.
-
Go your local Autozone, et al and see if they have any all thread / threaded rod. Stores used to keep this in stock in various lengths...
Latest posts
-
-
-
'78 K20 wiper and headlight switch selection help needed!- Latest: Goldie Driver
-
-
