Matt69olds's latest activity
-
Matt69olds replied to the thread TH400 trans service.I don’t have a part number, but the shiny tan gaskets that comes with the TransStar overhaul kits work well. If the pan is flat and... -
Anybody in readerland have a junk old school large single button style garage door opener remote? I’m looking for one to install in my...
-
-
Matt69olds replied to the thread Transgo kit 1&2 vs SK 400.Nick is a valuable asset to the transmission category of this forum. Lose the attitude and pay attention, you might learn something. I...
-
A GV is $3k and you're left with a non- lockup transmission. 4l80 cost is a wash and a simpler solution.
-
Matt69olds replied to the thread My 700r4 changes too early ?.Before doing anything, make sure the throttle opens all the way from the drivers seat. Make sure linkage flex, floormats, or something...
-
Matt69olds replied to the thread Distributor with limiter.I had one of the MSD ignition modules in my 455 powered 87 Cutlass, I was not impressed. While the car always ran, I always felt it...
-
Matt69olds replied to the thread No accessories power.Do all the accessories work normally with the ignition key in run? If so, you can rule out fusible links and fuses and most of the...
-
Matt69olds replied to the thread Alt Replacement Options? A bit confused..The 78 and 94 amp internally regulated Delco alternators are cheap and easy to find. The 105 and 115 amp CS series alternators are just...
-
Matt69olds replied to the thread Advice on Transmission Fluid Change for 1980 C10.Any GOOD engineer would design a product with routine maintenance in mind. A good engineer knows the importance of maintenance...
-
Matt69olds replied to the thread How many bolts hold the transmission on and where?.If you’re absolutely sure all 6 bellhousing bolts are removed and the trans still won’t come off the back of the engine, more than...
-
Matt69olds replied to the thread Advice on Transmission Fluid Change for 1980 C10.Yes, your pan has a drain plug. HydraMatic stopped installing drain plugs in the early 70s as a cost cutting move, so more than likely...
-
Matt69olds replied to the thread th400.As long as it’s sealed up, I wouldn’t think it would rust.
-
Matt69olds replied to the thread Rebuild th400 or 4l80e?.Turn the piston upside down, see if it will fit over the pin. Or remove the sealing ring and try to install it. If it still won’t fit...
-
Matt69olds replied to the thread Remove 4L60E.If you drop and drain the pan, there will be very little fluid (if any) that will come out of the extension housing. Same thing with the...
-
Matt69olds replied to the thread 350turbo out 700r4 in expected cost?.What he said!! ^^^^ Too many people think as long as the tv cable is tight at WOT, then all is good. While that is partially true...
