legopnuematic's latest activity
-
legopnuematic replied to the thread 74 C10 rear end interchange.Been there, done that :D -
If you pull the drive shaft and start the engine and put it in drive, you run the risk of pumping all your ATF out on your floor...
-
Are you SURE the float level is correct? It needs to be just below the sight glass window, if you shake the truck fuel should just...
-
Bought the gas powered Fortress 30 gallon air compressor for a shop I have with no electrical service. This girl is a beast. I picked it...
-
legopnuematic reacted to Mr Clean's post in the thread What new tools have you got lately? with
Like.
I got home this morning and a buddy reached out to me and asked if I wanted a tubing bender. I said how much? 50 bucks. So I drove 48... -
legopnuematic reacted to skysurfer's post in the thread What new tools have you got lately? with Like.
Pulled the trigger on a couple of things I've wanted for a while. Got the beam addition for my Daytona jack. Better support for...
-
Electronic spark control. It fights detonation. If your distributor has a 4 wire plug,that goes through the firewall you have ESC lots...
-
yep Tip-in vac switch - It’s in the same wiring diagram as the knock sensor in your other post. LINK- to other post
-
First image- looks like knock/ detonation sensor last image-probably plugs in transmission for TTC maybe the weird solenoid is the low...
-
legopnuematic reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
STILL no torque converter yet…so I made the traditional cardboard to-do list and put it under the wiper blade. Going to pick up some ATF...
-
legopnuematic replied to the thread Weird solenoid looking thing.Tip in switch for the factory ESC system
-
-
legopnuematic reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Sad.
Noticed my newest set of UP tail lights has started to crack yet again...that's 3 sets :dancingpoop:
-
It's unlikely that you are actually getting vapor lock with the symptoms you are reporting and the equipment you have. If it was vapor...
-
That's what I'm running. 781 heads with 496 rotating assembly from Slip White. I love my torque monster!
-
Which will be done in house ... The rollover boring stand allows to bore one bank than the other bank ...
