JBswth's latest activity
-
JJBswth replied to the thread Rochester Quadrajet Woes.Rebuild kits usually don't come with links and such. I would try to grab one from a junk yard for use as a parts carb. J. B.
-
JJBswth replied to the thread Rochester Quadrajet Woes.If your's is an automatic, I hope it wasn't towed with the drive wheels on the ground. That destroys automatic transmissions. J. B.
-
JJBswth replied to the thread Really tight front brakes!.The inside of the flex hoses can also split horizontally, so it can act like an open - close valve. Fluid will move toward the caliper...
-
JYou got the correct brake pads? Did you have to push the caliper pistons back into their bores to get the pads installed? Usually you'll...
-
JJBswth reacted to 75gmck25's post in the thread ANYONE USED VORTEC HIGH SWIRL HEADS ON THEIR GEN-I SBC? with
Like.
Are you sure about exactly what you have? Vortec heads and swirl are usually not used in the same sentence (although the Vortec port may... -
JJBswth reacted to CalSgt's post in the thread ANYONE USED VORTEC HIGH SWIRL HEADS ON THEIR GEN-I SBC? with Like.
IIRC to run the Vortec heads you would need an intake manifold and because Vortec water pump uses a bypass hose a small hole needs to...
-
JLEDs (light emitting diodes) Diodes only allow current to go one direction. Using them in dash lights generally isn't an issue. If...
-
JI have replaced many bulbs in old squarebodies. I also upgrade to LEDS for the difference in brightness. I have found through trial and...
-
JThe twist-in bulb holders are replaceable. You can also take a pencil eraser and gently clean the area they contact the printed...
-
JMost of the time the printed circuit board is wore a bit where the bulb sockets twist onto the gauge panel. Sometimes, if you have a...
-
JWhen you get to the knock stage pull 1 plug wire off at a time and put it back on and if the knock goes away on any of the cyl...
-
JDefinitely change the oil and filter now and check for shiny bits in the drain pan. I've never cut open a filter, but that may be a...
-
JJBswth replied to the thread Big block running hot. Can’t figure out the issue.But they didn't match the originals as far as the number of holes.
-
JJBswth replied to the thread Can't decide what to do. Suggestions? Thoughts?.I would just stick with stock. There is nothing wrong with the Chevy 350. They are easy to rebuild, and you won't have to worry about...
-
JJBswth reacted to thedog52's post in the thread Can't decide what to do. Suggestions? Thoughts? with Like.
Hello all. I have a 1991 Suburban 2500. It has the 350 TBI, and 4L80. It is 4X4. It is dead nuts reliable. I drove it to Florida lasy...
