JamesSam's latest activity
-
Unfortunately my bearing puller tool clamshell wasn't quite the right side for these Koyo bearings, it slipped and messed up the cage... -
Came up to the shop yesterday to get back on this thing. Took the time to slowly take it apart and measure everything as it came back...
-
Yeah you could, it's just more 'spensive
-
I have an honest question as I've not seen this be done before. Instead of the axle half shaft can't you just run a 2wd hub if you've...
-
I've known about this trick for years but never had to do it
-
:slap: :Wedgie:
-
@Old77 :321:
-
Here's the stub shaft bolted in
-
Yep, that's exactly how my truck is, same actuator. That's not a bad idea to bring it up in the engine compartment rather than just...
-
Yeah I deleted the front drive in my Tahoe and use those stub shafts like that to hold the bearings together. I took the diff actuator...
-
Thanks dude. I'm less bummed now that I've had a few days to cool off and talk it out with a couple guys. I'm gonna start with the rear...
-
What a kick in the balls, sorry bro.
-
Yeah, I'm realizing that my compound was still too thick looking back through my pictures. I'm gonna open the rear end back up first...
-
Something that helped me if you decide to tear back in to it and check the pattern was to really thin the marking compound out. Spin...
-
I certainly appreciate all the help you've already given me! I'll keep ya posted on what I find. I doubt I hurt anything unless...
