idahovette's latest activity
-
ILast night after work I decided to check my main bearing clearances with some Plastigage. Cleaned the mains in the block real good and...
-
Iidahovette reacted to SirRobyn0's post in the thread Differential swap / bought it, work and install now with
Like.
In the brake department my basic plan is to pull both sides apart, (which reminds me I need to bring my socket for the bearing retainer... -
Iidahovette reacted to TotalyHucked's post in the thread Problems with Fit on not one, but two new rear bumpers for 78 C10 fleetside with Like.
^This. These bumpers are actually very flimsy. Need to install everything loosely to start with, including the license plate bracket. If...
-
Iidahovette reacted to bucket's post in the thread Problems with Fit on not one, but two new rear bumpers for 78 C10 fleetside with Like.
You also don't have the license plate pocket installed. That pocket actually adds a lot of rigidity to the center of the bumper. Loosen...
-
IFor the gears themselves, look into Revolution Gear and Axle. @TotalyHucked just installed a set into his GMT800 (still a 10 bolt) and...
-
Iidahovette reacted to SirRobyn0's post in the thread Differential swap / bought it, work and install now with Like.
Well this might all go in a direction I wasn't planning. So I looked at prices and for me to just slam gears in it. With an...
-
IPedal cars are my favorite, lol.
-
II use what is essentially a telescoping stick, and measure off of the inside of the sidewalls. I set it to the front of the tires and...
-
IBut clearly seeing they are out is a lot different than them actually being toed out. It happens very often, where people look at their...
Latest posts
-
-
-
Old school Pioneer head unit, should I or should I not???
- Latest: plumtruckerd
-
-