HotWheelsBurban's latest activity
-
HHotWheelsBurban reacted to ChuckN's post in the thread What new tools have you got lately? with
Like.
Didn’t know they made these. Picked up a set of rubberized wheel nut sockets to protect the Halibrands. -
HHotWheelsBurban reacted to Zelph's post in the thread What new tools have you got lately? with Like.
^where did you get those?
-
HHotWheelsBurban reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Other side bracket getting the holes drilled out made some funny looking notches in some leftover 2x3 tube to see if my idea works to...
-
HThe rear mounts were easy. Square body cabs have the mounts inboard from the frame rails. I made a cross member and welded it in place...
-
HI have not used a spot weld cutter before, will the 5/16'' be large enough for the normal square body welds, or should I use a 3/8"??
-
HHotWheelsBurban reacted to Fluffyfreak505's post in the thread Square body on new chassis? with Like.
happen to have any pics of the cab mounts? thinking about doing the same swap with a dually chassis
-
HI was trying to find this thread a while back, but couldn't remember the OP's name.
-
HWelcome to the forum Jared. The thread poster (Joe) has not been around for over 4 years.
-
HNo, but a shortbed pickup would, wheelbase wise. Blazer is shorter.
-
HThis is my truck. I lost my old login credentials so I started a new username. I still have it and it has just under 300k on it. Folks...
-
HI'll check for pics. This was 4-5 phones ago...
-
HJust ignore the negative feedback, there's always going to be some people that disapprove, you just happened to run across them here...
