-
-
GGussie replied to the thread NP208 rebuild issue/problem.Hello, I'm ru ni g into same issue during my rebuild. Currently pilot bearing is flush and when I put n shaft w thrust bearing the end...
-
GHello friends. I'm putting the np208 out of my 86 k20 together. The output shaft (32 in attachment) shows only one thrust washer and one...
-
-
GHello, I didn't. Notice how the 3 rings on this shaft were spaced prior to needle bearings falling out. Anyone have and idea? Also the...
-
GGussie replied to the thread Np208 oil seal.Hello, another question on this np208. There are 3 washers/rings?..on the shaft but I didn't see how these were spaced before the needle...
-
-
GPutting them back to back keeps the fluids in the trans & case separated. The factory seals are usually a double or 2-way style. Back to...
-
GHello gang; I'm rebuilding my np208 and when removing the oil seal for the transmission to transfer case I had two 19236 oil seals in...
-
-
-
Loading…
-
Loading…
