fast 99's latest activity
-
fast 99 replied to the thread 5.7 back fires through carb but timing is good..40% is high but that alone isn't enough to condemn the engine. Old cold [when tested] engines can read high and be good runners. Was it... -
fast 99 replied to the thread High oil pressure after replacing pump.Or a SB Ford that twists distributor drive shafts and or destroys drive gear. Just went through that a couple months ago on my own car.
-
fast 99 replied to the thread High oil pressure after replacing pump.That's a slight bit higher than most SB I have seen but not high enough to worry about. After all, it's not a Chrysler that blows oil...
-
fast 99 replied to the thread 5.7 back fires through carb but timing is good..Generally speaking backfire into intake is lean from whatever cause: carb, vacuum leak, ignition misfire. almost any valve a train...
-
fast 99 reacted to legopnuematic's post in the thread Bolt hole pattern on the front of the heads with
Like.
All small block heads with accessory holes should be the same pattern, late 60s to vortec era. The 1986 and older is likely from being... -
fast 99 replied to the thread Leaking power steering fluid from Hydra boost unit..I used a local rebuilder for HB units. However, ones that had a staked push rod on the brake pedal side could not be rebuilt. Apparently...
-
fast 99 replied to the thread 55-75 OE distributor.Both materials, have seen cast iron more on late 50's vehicles. Some Corvettes used iron later into the 60's that included a tach drive.
-
fast 99 replied to the thread Power steering gear box.Inspect for worn front suspension parts. Possible shifting side to side.
-
fast 99 replied to the thread Hate it or Love it, it's sweet.Someone spent an incredible amount of time and material on that. Too bad they won't recover what the paint cost. Question where people...
-
check this out. Gotta admire the dedication to the project! 1994 ranger, could be yours for $8000 :banana-mario...
-
fast 99 replied to the thread Brake Booster Adjustment.Could the swinging pedal shaft be worn or tight?
-
fast 99 replied to the thread Engine oil lines..I believe you will find a small horizontal clip. If one is there, pull it out fitting will come off. Hard to say what is actually...
-
fast 99 replied to the thread Engine oil lines..Need to fix that. Those are engine oil cooler lines. If one ruptures it's likely to kill the engine before you have a chance to shut it...
-
fast 99 replied to the thread 1987 TBI Misfiring.Check for steady vacuum then compression after EGR as suggested. Most times the pintle in EGR can be raised with a finger. If no...
-
I think I have just enough epoxy left to give it an extra coat. I don't want to spray 2K and have to sand and smooth. I think the epoxy...
