fast 99's latest activity
-
fast 99 replied to the thread No crank. No power at all 1885gmc 2500.above first, follow 12v downstream until voltage is lost. Be sure to check grounds and inspect for dark, loose or corroded connections. -
fast 99 reacted to YakkoWarner's post in the thread No crank. No power at all 1885gmc 2500 with
Like.
If you have no power anywhere, I'd start with the basics - put a meter on your battery and make sure you have power (yes I know you ran... -
If you had both boxes apart and reassembled,you set both of those clearances on assembly,the endplay gets set by how tight the end...
-
fast 99 replied to the thread '77 C10 350/TH350 ignition problem.At 6:43 red greased area on top may be holding it. Part of tilt assembly. Should be able to release with the tilt lever. Have the tilt...
-
fast 99 replied to the thread '77 C10 350/TH350 ignition problem.If tilt assembly is loose at all now is a good time to tighten the lower bolts.
-
fast 99 replied to the thread 87 v10 transmission and ac compressor swaps.Inspect the orifice tube/filter. Lots of metal better flush it and refill with correct quantity of oil.
-
fast 99 replied to the thread 87 v10 transmission and ac compressor swaps.is the compressor pully seized or the compressor itself? If it had an internal failure there will be metal tossed throughout the system...
-
fast 99 replied to the thread 87 tbi 350 popping at idle and running rich.Didn't go back and read all the replies has anyone suggested a possible exhaust leak?
-
fast 99 replied to the thread 73 Blazer 350 spark plug stuck.If the porcelain can be blown out as suggested I would try to drill and tap whats left provided there is access. Use grease on the bit...
-
fast 99 replied to the thread Engine mount, old or new?.I usually replaced the mounts. Many times upper bracket attached to the block will be laying hard against the cross member or frame...
-
fast 99 replied to the thread Need help identifying sloppy driveshaft/diff play!.High idle?
-
fast 99 replied to the thread Spark plugs.CR43, C indicates commercial, ground electrode is wider heavier duty. Primarily designed for 2 ton and larger trucks. Will work on...
-
It will be an ACDelco R45TS. That was the specified plug for almost every small block(and some big block) GM engine for decades. My 71...
-
fast 99 replied to the thread Sagging doors: where to start?.Inspect area around hinges for cracking of the door frame, especially upper hinge. If found will need to be repaired or door replaced...
-
fast 99 replied to the thread Engine running rough.Check engine light on has stored code. Doesn't need to be running to retrieve code. Will be stored for around 50 key cycles if it...
