fast 99's latest activity
-
fast 99 replied to the thread Engine running rough.Code 12 indicates there are no stored codes. If present, system will flash codes from the lowest number first. You probably... -
fast 99 replied to the thread Engine running rough.Fuel pressure? Should be 9-13 although I have seen GM TBI that ran poorly at the lower spec. Check grounds. Please do not toss any...
-
fast 99 reacted to TotalyHucked's post in the thread Help working with wheel arch replacement with
Like.
Ohhhh I went back to re-read and see what he's saying. OP, I assume you're working with one of these? (this is for a Blazer, we don't... -
fast 99 replied to the thread Rebuilt Stock Steering Column or Aftermarket?.$1000 is awful expensive for a stock unit. Provided all the hard parts are good, switches, bearings and tumbler will be around $100. I...
-
fast 99 replied to the thread 87 tbi 350 popping at idle and running rich.Check vacuum, if low or not steady will be rich. Popping in exhaust has a myriad of causes. From ignition misfire to loose valve guides.
-
fast 99 reacted to Ricko1966's post in the thread 87 tbi 350 popping at idle and running rich with Like.
First thing I'd do is a power balance test. If you are running equally on all cylinders,I'd test fuel pressure,map sensor,coolant...
-
fast 99 replied to the thread Paint Source for 1983 K20.A semi retired friend still does higher end painting on one or 2 cars a year. Automobile completes he orders 2 gallons of base. Usually...
-
-
fast 99 replied to the thread Paint Source for 1983 K20.And buy much more than the project will need if this will be a longer duration paint job. Mix colors change, matching down the road may...
-
fast 99 replied to the thread rock auto discount code for 10/24 to 11/8/24.I usually received a discount code in an e mail a few weeks after placing an order. Good for 4-6 weeks. edit, My discounts have always...
-
fast 99 reacted to Goldie Driver's post in the thread 1978 k35 proportioning valve question with Like.
I would leave it alone. The OE are better built and my experiment with an aftermarket PV2 unit, I believe, gave no better results and...
-
fast 99 reacted to Ricko1966's post in the thread Project is stalled. Cannot solve brake problem with Like.
Did you adjust the brake booster pushrod properly? Not the rod from the pedal to the master,the one in the booster that pushes on the...
-
fast 99 replied to the thread Project is stalled. Cannot solve brake problem.When bench bleeding a master do not bottom out the piston. It is possible to cut one or more cups doing so. Are the caliper bleed screws...
-
fast 99 replied to the thread LMC Dash Pad Supplier.Has anyone bought an 81 up pad recently? One I purchased [a Dashes Direct part] did not fit the cluster bezel area upper left corner...
-
-
Platigage won't tell you if the bearings are standard .010 etc. It will tell you if clearances are correct. When you resize a rod or...
-
fast 99 replied to the thread 1966 Ford Galaxie 500.I could certainly be mistaken but can't remember seeing a Cleveland or Windsor based 351 in anything older than 69. Have seen small...
