Craig Nedrow's latest activity
-
73-74 Is a different motor apparently - to find anything in Australia will be tuff - seems like I got to do a bit of fabrication /... -
I believe thats the same wiper motor GM used on everything in that era. A replacement will be easy to come by.
-
I believe it's 73-76. Rockauto should have it.
-
Heres my 3 port pump, for another example
-
not sure about 85 but there is a chance HD emissions without evap may have been offered in 85, if it was, there would be short little...
-
If that 2nd metal line ends very close to the fuel pump, then is probably the fuel return line. The picture I attached shows my...
-
also even if the fuel wasnt vapor in the line, the moment it starts sucking gas , you will cause it to boil (under a vacuum, the boiling...
-
Sounds like the return line
-
How should I tell the difference? In my '85 truck there is a smaller metal line right below the fuel line and it was not connected to...
-
The return setup would be preferred with today’s lousy gas. The 3 port pumps have a tiny orifice in the return fitting, basically a...
-
Are you sure you have a fuel return line,and you aren't looking at a vent line. If you have a return a 3 port pump with return would be...
-
Craig Nedrow reacted to ali_c20's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with
Like.
When I did the swap 203 to 205 on my K5 I had to have the front driveshaft shortened and the rear lengthened. I have a TH350 and GM... -
Craig Nedrow reacted to Strick's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
Is it a Dana 60 truck? I know that doubling the cases makes for the length difference but I've never had to replace the front driveshaft...
-
Craig Nedrow reacted to DonN's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
No it's not. The 203 shaft is longer. I just put a twin stick 205 behind a TH350 in my K10 and had to have the front shaft shortened and...
-
Craig Nedrow reacted to Ricko1966's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
You should have capitalized underlined and quoted" I AM NOT CHANGING TRANSFER CASES" You'll know better next time.
