Craig Nedrow's latest activity
-
Craig Nedrow reacted to TotalyHucked's post in the thread Fair price to switch a V10 front and rear diffs to 373 from 308 gears with
Like.
What all is involved in that quote? Brand of gears? Locker or posi? All new bearings/gaskets/seals I assume? That does seem a little... -
Craig Nedrow reacted to Strick's post in the thread Fair price to switch a V10 front and rear diffs to 373 from 308 gears with Like.
I just swapped from 3.08 to 4.56 on my '87. I put Spartans on both ends too & it costed me about $1500 total in parts. That is with me...
-
Nevermind, don't use coconut oil. Carry On...
-
Craig Nedrow reacted to HUFFINCOSMOLINE's post in the thread Your preferred leather conditioner with Like.
This stuff has the best aroma. Your leather seats will become like a scratch and sniff sticker. Conditions good as well.
-
Craig Nedrow reacted to Rustisbest's post in the thread Your preferred leather conditioner with Like.
Huberds...might smell like a campfire for a while though :gr_grin:
-
Bought some leather seats out of a boneyard that were hard as a rock. I used Fluid Film. Stuff doesn't hurt anything else I figured...
-
Craig Nedrow replied to the thread old guy newbie.Geez Richard, you ol’ coggie, yer gonna fit right in, cause there’s a bunch of us here. Early and late model paint on my trucks.
-
-
Hello Group, Retired FF here and old guy as well. I am just about to pull the trigger on an 81 swb, this will be my wife's truck and a...
-
Welcome from just south of you in Winder/Auburn! I would start by jacking up the rear, make a mark on the driveshaft and then spin a...
-
I just bought a yukon yesterday from Amazon for like $240~, from the Amazon store. Not a 3rd party. They might still be on sale, I'll...
-
I have used the Detroit True Trac as well as a Yukon Dura Grip. I did have to replace the Detroit due to a later bent axle tube putting...
-
No, all of the issues and changes were pre-97 where these were installed on 350's, 305's, and v6's. He will want to stay away any early...
-
he would also have to make sure he has the TCC lockup to match , 99 should be aftere they went PWM but not sure if they had the ECCC...
-
Key things to look for if the NP203 shifter is giving you a hard time: #1: Check alignment of shifter rods. The whole shifter can...
-
I beat the hell out of my NP203. And the only "issue" I ever had was shifting. She was sometimes stubborn to shift if you were already...
