Craig Nedrow's latest activity
-
Craig Nedrow reacted to Ricko1966's post in the thread Need help with my 700r4 TTC wiring harness with
Like.
Hook your low vacuum switch up it will make the truck more drivable without it your converter will lock going into 2 or 3rd depending on... -
Craig Nedrow reacted to BigSW's post in the thread Need help with my 700r4 TTC wiring harness with Like.
Okay thank you. I am going to hook the vacuum line to a "Timed Vacuum" Port on my Edelbrock Carburetor. So can I just move the EGR wires...
-
Craig Nedrow reacted to BigSW's post in the thread Need help with my 700r4 TTC wiring harness with Like.
I do have the low vacuum switch but not the thermal switch.
-
Craig Nedrow reacted to Ricko1966's post in the thread Need help with my 700r4 TTC wiring harness with Like.
Looks to me like tcc and egr bleed are both picking up power at splice 383 in which case,you don't need to do anything. Hopefully...
-
Clutch Selection This is where I hit a brick wall. I had read several places that you could use a factory clutch setup for the...
-
Craig Nedrow reacted to bluex's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
This also should have only required a pressure plate change to the older 95 an down style. The bellhousing is different because of the...
-
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Ah interesting. I was wondering. I just recently replaced the NV4500 in my 98 with one from a 95. I figured one for one swap, be...
-
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
I gotcha.. I have the orginal 11inch clutch and pressure plate off my 305. I should bolt them up to a flywheel and put them in the...
-
Craig Nedrow reacted to Ricko1966's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
^^^^ use the pressure plate that matches your engine and a clutch disc that matches your transmission,may have to look at a few to pic...
-
Craig Nedrow reacted to bucket's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Glad to hear from you again! Are you sure you're engine is an '86? '86 was the first year for a 1-piece rear main seal with the smaller...
-
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Thanks. Im still alive, just alot going on. Haven't been real active here, but still try to check in now and then. Still working on my...
-
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Okay i have kind of an odd situation. Looking to swap a NV3500 into my 86. Found alot of threads here, but no one has my exact...
-
Look at your driveline mounts for wear/play. These engines move all over the under load. Your chattering might be due to the springs in...
-
So I pulled the driveshaft and brought it to the driveshaft shop. It was a little out of balance, but they said due to the long length...
-
Thanks for the information on this. I'll look into it. It's not really chirping but I feel it a little in a slow turn pulling on to the...
