Craig Nedrow's latest activity
-
If you’re going through the process of blasting it clean to bare steel, you don’t want rust reformer type coating, you want paint... -
^This. While I can’t imagine a world where I’d want one, the mpgs are what got me thinkin about diesels. Growing up in the era of...
-
Not to be outdone by the daughter, the wife helped with changing the oil and filter on her Jeep. :love62: I needed the Jeep a bit...
-
Yes, it’s a LS5 454 from a 71 Chevelle. A bit overkill for a Blazer but it’s hell for cool. Daughter picked up the basics pretty...
-
I have one that always seemed to work really well and the engine ran strong. This last summer, the truck randomly wouldn't start and it...
-
The 4L75E has a billet 4th gear servo but looks like any other later 4L60E, apart from that. The TH375B is a beefier version of the...
-
I wondered that too. Sometimes he mixes things up and maybe that's what it is. Man I wish I wasn't in too much of a hurry to get a...
-
Wondering if they meant TH375?
-
The 4L75E is a crate HP 4L60E variant sold over the counter by GM as an alternative to the 4L80E where power levels exceed 600 but where...
-
Traded a subaru and getting an 83 C10 with a knocking good guys 350 and a replacement engine to go with it so that's cool. He said it...
-
Craig Nedrow reacted to legopnuematic's post in the thread NP208 leaking from shift select arm/bracket with
Like.
No problem, also while you are under there make sure the transfer case vent is not plugged up, a plugged vent won’t do you any favors... -
Craig Nedrow reacted to VAL's post in the thread NP208 leaking from shift select arm/bracket with Like.
legopnuematic, Thank you. I was praying there wasn't a seal inside the case.
-
Craig Nedrow reacted to legopnuematic's post in the thread NP208 leaking from shift select arm/bracket with Like.
You should be able to. Might be worthwhile to remove the front driveshaft to get a little better access. Remove the nut holding the...
-
Craig Nedrow reacted to Frankenchevy's post in the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381 with Like.
-
Craig Nedrow reacted to Frankenchevy's post in the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381 with Like.
A factory vortec era pump is perfectly fine for engines up to 400hp or so. What isn’t correct is the proflo 4 regulator you have. You...
