Craig Nedrow's latest activity
-
Craig Nedrow replied to the thread Old Bedliners.Mine was a little different in the 73 K20, but when I started my build, I pulled it, and there was quite a bit of rust.....I will Rhino... -
-
Craig Nedrow replied to the thread No accessories power.Pics First is off position, second is power on, next position on second pic going left would be start. On my 73 K10. I use that little...
-
-
Hey Ricko1966… when you say switch are you talking about the key switch or the switch at the end of the rod farther down the column. I...
-
Man i got into that column today and that was a job. I got as far as pulling the turn signal harness as far as i could and realized it...
-
If you can feel the detents in the switch and everything works as it should in the different detent positions,my money is on the...
-
Yes you are correct!!! I went back in because i tore into tge steering column and got no happiness there. I did adjust it to where i got...
-
Here’s where the screws should be
-
There should be 2 screws holding the switch to the column, the holes in the switch are slotted allowing for about 1/4” or so of...
-
I located this switch however the only adjustment i found was the hi lo beam switch. None in the ignition but i did use bent needle nose...
-
^^^^ Basically this There may be a bit of a compromise on the best position for the ignition switch. When its perfect each key...
-
I think @Snoots has got it, when you turn the key to Start or run position it pulls on the switch (rod moves up towards driver), so...
-
It's located near the bottom of the steering column. There are 2 screws holding it there. Loosen them (don't remove) and you can move...
-
Ignition switch adjustment needed.
-
Thx for the quick response to my question! You guys rock!!
-
I agree, switch may be out of adjustment. Another common problem is that the small rack on the end of the key cylinder is cracked, and...
