Craig Nedrow's latest activity
-
After taping the pump yesterday the pump works like it should it fills up the filter "not very quickly" but it does and the truck sounds... -
Side note we have the same color suburban. Mines an 89. I assume yours is too. Do you by chance have any spare body panels ?
-
Backfiring is a lean condition. The plugs also look a little lean. You had to tap on the pump to make it come alive.... The pump is...
-
the truck had been running good for the last 4 months until it got colder out then it was constant hard starts last night the fuel pump...
-
Craig Nedrow reacted to GTX63's post in the thread How many bolts hold the transmission on and where? with
Like.
None of the housing bolts hold the transmission in place. Those are only there to dampen vibration and be broken off with the ears. The... -
Craig Nedrow reacted to Ricko1966's post in the thread How many bolts hold the transmission on and where? with Like.
I don't even pull the transmission doing flexplates,I've written it up before,the condensed version is replace 2 of the engine to...
-
Craig Nedrow reacted to grummy's post in the thread How many bolts hold the transmission on and where? with Like.
Do it a few times in a week and it gets real easy ! I did an (1) out, in, (2) out in and an (3) out in all in a week while I was...
-
Craig Nedrow reacted to JD Miller's post in the thread How many bolts hold the transmission on and where? with Like.
Correct procedure is to Remove the flex plate bolts before the bell housing auto trans case bolts and before separating the trans case...
-
Craig Nedrow reacted to Matt69olds's post in the thread How many bolts hold the transmission on and where? with Like.
If you’re absolutely sure all 6 bellhousing bolts are removed and the trans still won’t come off the back of the engine, more than...
-
Craig Nedrow reacted to 77Dmax's post in the thread How many bolts hold the transmission on and where? with Like.
Step one is to pull the crossmember to tilt the trans down. Also make sure to pull the distributor cap on a chevy. With the trans tilted...
-
Craig Nedrow reacted to NickTransmissions's post in the thread How many bolts hold the transmission on and where? with Like.
Then you don't have a flywheel, you have a flex plate...They are not the same nor can the terms be used interchangeably...Just FYI if...
-
Craig Nedrow reacted to TheBigBlue2500's post in the thread How many bolts hold the transmission on and where? with Like.
Been using an extension but when it's 18 to 20 degrees and your on cold cement and your fingers are numb it's really no fun and I don't...
-
Craig Nedrow reacted to bucket's post in the thread How many bolts hold the transmission on and where? with Like.
Hopefully this doesn't turn out like that old thread where the dude asked how many bolts hold the engine in the truck. But I'm betting...
-
Craig Nedrow reacted to NickTransmissions's post in the thread How many bolts hold the transmission on and where? with Like.
Do you have an auto trans or a manual?
-
Craig Nedrow reacted to JD Miller's post in the thread How many bolts hold the transmission on and where? with Like.
Its a piece of Cake .....Get a 1/2" Female - 3/8" Male, 35" Long, Impact Extension...
