Craig Nedrow's latest activity
-
Update:I have removed it all. This is what they had going on connecting across both tanks. Also removed both fuel tanks because I have... -
Yes they put two fuel pumps instead of original valve. Some of the rubber hoses were leaking where they clamped onto hard lines. So I...
-
Yeah, it looks like the truck had a 6-port valve and they couldn't find one, so they used a pair of 3-port valves. I don't see why that...
-
Dad's ole C20 Crew has a selector valve with one wire like the one in the pic. It appears that your truck has two installed for some odd...
-
Welcome! Stop, breathe, think. The mess you have needs to be fixed, safety issue. The question is what are your plans for the truck...
-
Craig Nedrow replied to the thread 8 lug slots...?.Hey Tim, we talked about this some at the shop, and you may be able to buy the rim without any holes in them, I saw that somewhere when...
-
Craig Nedrow replied to the thread BBC 489 build.After months of studying, searching, and what the budget would allow, I bought a cam. The 265 AFR might limit my rpm and certainly some...
-
Craig Nedrow replied to the thread BBC 489 build.Removed the freeze plugs, and the back cam plug. All pipe plugs, had to drill out a couple that were in the front oil galley on the cam...
-
-
Craig Nedrow replied to the thread BBC 489 build.More done today. Before I pushed the pistons out, I scrap off the crud in the first picture, so it looks like the second. Pistons came...
-
-
Run compression. Check for slop in the timing chain. Check the timing chain while you are doing compression. All plugs out,dist cap off...
-
Craig Nedrow replied to the thread BBC 489 build.Here are some pictures of the hydraulic flat tappet cam. It has been excellent, torque off the bottom, but all in by 5000. Smooth idle...
-
-
Craig Nedrow replied to the thread BBC 489 build.lower end is very clean, side to side rod clearance id .020-022, and end play is .008.
-
-
Craig Nedrow replied to the thread BBC 489 build.I started tearing down the block, am very encouraged, everything inside is spotless, and all the used parts look new. Bore is even very...
-
-
Craig Nedrow replied to the thread BBC 489 build.here is the carb I plan to start with, may be too small 850cfm, but adjustable everything. My brother had it on a stroked 440 think 489...
-
-
Whens the last time its gotten plugs wires and a coil? Failing to run on ether is the red flag, its not a carb issue i dont believe
