Craig Nedrow's latest activity
-
Thanks. I have a rebuild kit and I have considered going that route. I'll check out the company you mentioned. I may buy a reman unit... -
IMO, it might be worth it to rebuild as the kits are pretty cheap. I just ordered an ACDelco rebuild kit off amazon for like $30. I also...
-
Holy ****! If your parking brake works then that’s a clean truck. Assume it released. Back to your regularly scheduled program. Haha...
-
Maybe the wheel cylinders are sticking... sounds like the rear brakes are heating up which usually means they're sticking. Over...
-
Well everyone, thanks for all the help. I found the problem. I have my dash pulled apart for a new circuit board and LED lights so my...
-
Not a heat gun like what you heat up shrink wrap with, an infrared thermometer. Take the truck for a short drive, get out and check the...
-
Smart people.
-
Are you sure it's brakes and you didn't over tighten the front bearings.Are you sure you got the correct bearings? How did you tighten them?
-
One issue at a time. How’d the brakes work before you did the bearings? Because just taking them off and back on should make zero...
-
Yup, calipers can stick for this reason too. Best thing is to replace the calipers and hoses; then you know you have clean parts. And on...
-
Another possibility is bad calipers. When pads wear caliper pistons move outward take up the wear. When pushed back old piston surfaces...
-
Check out clay smith cams. Just what you're looking for.
-
Craig Nedrow replied to the thread BBC 489 build.Ha, no all NA, BUTTTT....I did order heads today. I have literally spent a hundred hours researching this, and though there are not the...
-
Craig, Not yet. Had some health issues get in the way. I did download the service manual that Britt led me to. Looks like will be much...
-
Craig your BBC knowledge makes me shiver with honor, I'm tuned into this thread like the last episode of Yellowstone, better yet SOA...
