ChuckN's latest activity
-
Running an electric pump,if you mount it in the rear and blow through the factory pump. You can maintain all your factory lines in the... -
For future readers - water temp and tach both get fed thru the PF4 BMI and outputs directly into the DD gauges so no need to run the...
-
Just future readers - i did ask, and they do not have anything other than the single BIM bracket
-
Yeah I've had my Squarebody Syndicate versions for 3 years and nearly 40k miles now, these are by far the best gauges on the market...
-
ChuckN reacted to brooksman9's post in the thread What have you done to your square lately?? with
Like.
That place looks like heaven. -
ChuckN reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
Stopped by Darlington on the way home from Myrtle
-
ChuckN replied to the thread What have you done to your square lately??.I’ll check it out! Today was a challenge. So, the torque converter was a “bolt through “ design meaning there’s no threads in the...
-
-
ChuckN reacted to JamesSam's post in the thread What have you done to your square lately?? with Love.
This just posted from Yeah Buddy for you Chad @ChuckN ...
-
ChuckN reacted to JamesSam's post in the thread What have you done to your square lately?? with Sad.
New gaskets and TBI hardware finally came in an the TBI was rebuilt, solid this time around with no leaks. The injectors were spraying...
-
ChuckN reacted to justhorns's post in the thread What have you done to your square lately?? with Haha.
Don't sit on that donut!
-
ChuckN reacted to Tank6x2's post in the thread What have you done to your square lately?? with Like.
I went out to LS Fabrication and had them bead roll me a whole Driver side firewall panel versus the partial one sold with the kit they...
-
Ya doing a trans on the floor on jackstands is awful. It's not much better with a lift an legit trans jack though...
-
ChuckN replied to the thread What have you done to your square lately??.Man, getting a half filled torque converter into a transmission for both “clunks” to seat it in while on a wobbly transmission jack was...
-
ChuckN reacted to Grit dog's post in the thread What have you done to your square lately?? with Love.
Hell yeah!
-
Also, here are the flow charts from the service manual to help diagnose issues
