ChuckN's latest activity
-
ChuckN reacted to 84_c10_GMC's post in the thread Fuel gauge to tachometer, clock to fuel gauge with
Like.
The summit tach is 3 wires off back of the guage. Ground power and signal wire. Other post on here used an inline fuse that plugged... -
ChuckN replied to the thread Fuel gauge to tachometer, clock to fuel gauge.Hey Alex, when I did that conversion I used the LMC tach kit. I could be wrong, and I don’t know if Summit includes any provisions for...
-
-
ChuckN replied to the thread What have you done to your square lately??.AFR gauge is a go. Took it for a drive, way too rich at idle in gear. Leaned it out, raised the idle back up a bit, much improved. I’d...
-
Thanks will do it's still pretty far north but it's been a dry winter and fires are probably gonna be bad this year my friend is about...
-
ChuckN replied to the thread What have you done to your square lately??.Be safe out there!
-
Had to switch gears from the bull bar to getting the gooseneck hitch on the 83 some pretty bad wildfires near me and my buddy asked if...
-
ChuckN reacted to Ricko1966's post in the thread Need to replace rubber fuel lines on top of both tanks…. with Like.
Dropping tanks don't eff with the tank straps. Unbolt the the tank brackets from the frame. Tank straps are a bit#h and 1/2 the time...
-
ChuckN reacted to WesN's post in the thread Need to replace rubber fuel lines on top of both tanks…. with Like.
I lifted the box by putting a 4”x4” post between the joists of the garage and wrapped a chain round it. Hooked a come along to Strapes...
-
ChuckN reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
Just FYI, your truck is not OB2, it's OBD1. You have to use the paper clip method and count the blinks in the dash to get the codes
-
ChuckN reacted to TotalyHucked's post in the thread Thinking about a new smaller steering wheel, comfort grip or forever sharp? with Love.
My dad's 6', my mom's 5' 2" so I landed right in the middle lol Yeah it's about perfect for the gauges. I usually set the tilt a tad...
-
ChuckN replied to the thread What have you done to your square lately??.Hope you get it sorted soon! It’s hard to sleep when our trucks aren’t running right. Seriously. Or at least I don’t sleep well. I’m...
-
ChuckN reacted to Redfish's post in the thread What have you done to your square lately?? with Like.
Nope, the bearing is just raising hell and making a lot of noise when the belt tension is high. I cannot see the pulley getting out of...
-
ChuckN reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
Jealous!! My Uncle in law has a computer plug in do-hickey, OBD2(I think) and we are going to see if it and the dash tells us something...
-
ChuckN replied to the thread What have you done to your square lately??.Just got back from the muffler shop- they welded the O2 sensor bung in the driver side, then the offered to put one in the passenger...
-
ChuckN replied to the thread Thinking about a new smaller steering wheel, comfort grip or forever sharp?.Well, we’re all shrinking lol. I do like the deep offset of that look. My dads ‘68 vette had a three spoke steering wheel from the...
