ChuckN's latest activity
-
ChuckN reacted to 87scotty's post in the thread What have you done to your square lately?? with
Like.
Then washed and rain x windows lack of wipers needs new turn signal switch.... poor barely ran 468 :-( needs cleaned up. -
ChuckN reacted to 87scotty's post in the thread What have you done to your square lately?? with Like.
New to me door 50$ better than the windowless rotten door I had I'm so excited to have a dry and warm ass.
-
That motor should be cut for PC seals. Should only take an afternoon to fix it.
-
ChuckN replied to the thread What have you done to your square lately??.Replaced the taillight gaskets since one was missing. Now I’m in the cab trying to figure out the radio wiring butchery so I can sort...
-
-
ChuckN replied to the thread What have you done to your square lately??.Nice! Since on the 81-87 the badges are hard to get to the backside, I’m just going to repaint mine- picked up some tiny brushes while I...
-
ChuckN reacted to mxer147's post in the thread What have you done to your square lately?? with Like.
Added some orange, kinda pops.
-
ChuckN reacted to legopnuematic's post in the thread What have you done to your square lately?? with Love.
Moved it out of the shop and into my friend's unit to make room to assemble the 4 post lift. First time I've moved it in a few months I...
-
TBH if you're going to toss it, cut it down almost flat and just inside the wheel bumps. I use it for a creeper/ transmission...
-
My gauge uses the LC-1, and the instructions tell you to mount it under the vehicle near the O2 sensor. The LC-2 is part of a different...
-
ChuckN replied to the thread O2 sensor question.Yeah, good call. Sounds like we have a similar setup- mine is also Innovate. I was going to mount the control box inside the cab- if I...
-
I have an Innovate AFR gauge, and the “control box” mounts on a frame rail under my truck - supposed to be weatherproof. From there I...
-
ChuckN replied to the thread 1978 chevy 350 issue.Yep, apparently it was a common issue- my ‘76 Nova when was given to me to work on while in high school had flat cam lobes.
-
My '80 Camaro had that issue. Turned out to be worn Cam Lobes on 7 & 8 Exhaust. Someone back in the day told me that GM was using...
-
ChuckN replied to the thread O2 sensor question.Thanks guys! Sounds like pulling the pins and reinstalling them as the easiest way, the connector goes right to the control box and does...
-
With the proper release tool wires can be removed from connector and re-installed. It's a common repair procedure for bad connections.
