Camar068's latest activity
-
Camar068 reacted to Powerhouse Ranch's post in the thread What have you done to your square lately?? with
Like.
Put the military blazer under the knife today. needs rockers and a good amount of floor. Good to be back fabricating again. -
Camar068 replied to the thread New to GMSB from Oregon.Welcome! We are pic hungry....feed us lol.
-
Camar068 replied to the thread 1987 LS swap , dual tank, primary left side in tank fuel pump & Right side tank convert to a transfer tank setup to fill left tank anyone done this?.32 gallon fits fine. If you've got both tanks and have the valves, etc, put a sender/pump in both tanks and switch from one to the...
-
Camar068 reacted to 75gmck25's post in the thread 1987 LS swap , dual tank, primary left side in tank fuel pump & Right side tank convert to a transfer tank setup to fill left tank anyone done this? with Like.
Maybe simplify your life and swap to a single Blazer or Suburban tank at the back of the truck. Not sure if the big Suburban 40 gallon...
-
Camar068 replied to the thread What have you done to your square lately??.I put it on the wiper cowl and the paint wiped off the next day. I really didn't want to sand all those slots by hand lol.
-
Camar068 replied to the thread What have you done to your square lately??.I hadn't either until my dad told me about it last year.
-
Camar068 reacted to Truck82's post in the thread What have you done to your square lately?? with Like.
Never heard of this being done like that. I’ll have to give it a try
-
Camar068 reacted to Truck82's post in the thread What have you done to your square lately?? with Like.
Cleaned the oil pan. Putting on a new gasket because the old one had a million different leaks and made the whole thing nasty… it’s not...
-
Camar068 replied to the thread What have you done to your square lately??.if you have time, take some citristrip and coat the top and then put saran wrap over it so air won't get to it. Then do again for each...
-
I take the easier approach. If a light goes out and half the strand doesn't work, I just pitch the strand and use a new strand, lol.
-
Camar068 replied to the thread Power tool storage.amazon. they'll fight each other when you install so hold tight (or flip around) until they hit metal. Lose hold of one it will...
-
Camar068 replied to the thread Steering Column needs to be rebuild.Can be done with time and patience (pdf link below). There's also a video of a young student that walks you through it with good images...
-
Camar068 replied to the thread Power tool storage.Not sure if I shared this one or not. Cheap magnets for easy nut driver storage. I need to get some more magnets for the ball end...
-
-
Camar068 replied to the thread 86 1/2 ton gears needed for 33” with new 383.about 6 years ago I had mine regeared from 3.08 to 3.73 with Richmond gear Excel...only complaint I have is I didn't do 4.10. Very...
-
Camar068 replied to the thread Plastic thread repair.Is it a thread size you can match? My thought would be fill in the threads with JB weld, good superglue, etc and then re-thread it...
