Camar068's latest activity
-
Camar068 reacted to Truck82's post in the thread What have you done to your square lately?? with
Like.
Cleaned the oil pan. Putting on a new gasket because the old one had a million different leaks and made the whole thing nasty… it’s not... -
Camar068 replied to the thread What have you done to your square lately??.if you have time, take some citristrip and coat the top and then put saran wrap over it so air won't get to it. Then do again for each...
-
I take the easier approach. If a light goes out and half the strand doesn't work, I just pitch the strand and use a new strand, lol.
-
Camar068 replied to the thread Power tool storage.amazon. they'll fight each other when you install so hold tight (or flip around) until they hit metal. Lose hold of one it will...
-
Camar068 replied to the thread Steering Column needs to be rebuild.Can be done with time and patience (pdf link below). There's also a video of a young student that walks you through it with good images...
-
Camar068 replied to the thread Power tool storage.Not sure if I shared this one or not. Cheap magnets for easy nut driver storage. I need to get some more magnets for the ball end...
-
-
Camar068 replied to the thread 86 1/2 ton gears needed for 33” with new 383.about 6 years ago I had mine regeared from 3.08 to 3.73 with Richmond gear Excel...only complaint I have is I didn't do 4.10. Very...
-
Camar068 replied to the thread Plastic thread repair.Is it a thread size you can match? My thought would be fill in the threads with JB weld, good superglue, etc and then re-thread it...
-
Camar068 replied to the thread Introductions! New member from Florida.Welcome, if in the Destin/FWB area....go eat some wings at Buffalo's Reef for me.
-
Camar068 replied to the thread High Pressure Fuel pump install.care to share a pic of the plumbing to the wheel well?
-
I put mine in the wheel well, and have no gas door on the outside of the bed. That really confuses folks.
-
Camar068 replied to the thread Installing Tach in a Non-Ghetto Way?.anyone know if that tach is stock? That's what I'm wanted for my K10. I'll have to start digging again. I know LMC has the 7k rpm...
-
Camar068 reacted to bucket's post in the thread 86 1/2 ton gears needed for 33” with new 383 with Like.
4:10 minimum. 4.56 ideally. I ran the 700r4/3.73/33" combo for a long time and to be honest, it absolutely sucks.
