Camar068's latest activity
-
Camar068 reacted to TommyGuns's post in the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381 with
Like.
Even if I go with the EP381, that pump is rated less than the "required" flow rate of 57 GPH per the Edelbrock Pro Flo 4 instructions... -
Camar068 replied to the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381.EFI I would say yes.
-
Camar068 replied to the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381.Good luck finding an EP381 let alone for a decent price. I paid $62 for mine 7-8 yrs ago. Well over $100 now at only a few websites...
-
Camar068 replied to the thread Gear Ratio.thx, figured you were getting more than just a gear change...and other variables.
-
Camar068 replied to the thread Mastercraft 31's or 32'.got 6-12 months....when u think about it lol. Planning ahead. Thx Dude
-
Camar068 replied to the thread What new tools have you got lately?.cheap lift for whatever. Bed lift mounted to garage ceiling, deer winch for bed....w/e. Cheapest I've seen it. HF 2000 $55
-
Camar068 replied to the thread New Gas tank installation.hmm....someone design a cheap/efficient 1 button lift to raise the bed 1 foot. Take the bolts out of the bed floor....hit a button...
-
Camar068 replied to the thread Engine & transmission removal & reinstall general tips.nothing meant, but I've always steered clear of adding bolts/chains on the intake especially aluminum. Younger days when intakes hit...
-
Camar068 reacted to Tonimus's post in the thread Engine & transmission removal & reinstall general tips with Like.
I would advise pulling the radiator just to be safe. It's only two more lines if you're running the trans cooler. The carb plate is...
-
Camar068 replied to the thread 04 LM7 into 87 K5.Also, I deleted the trans range sensor. One less thing to fail later and was a simple programming for 1 signal wire on pin 34 for...
-
Camar068 replied to the thread Mastercraft 31's or 32'.Still got this to measure from fender to ground at center of hub? Hoping I'll get lucky with the new monroe coil overs and have...
-
Camar068 replied to the thread Gear Ratio.Sorry for being vague, why is the price so high? I had mine changed (front/rear) for about $1,200 and that included new front wheel...
-
Part 2 The shop had to cut new slots in the foam for the correct listings, and fill the old ones. The factory lines are left to right...
-
I know that this has been a topic of many discussions on these boards. A lot of us love the look of bucket seats and a console in our...
-
Camar068 replied to the thread 04 LM7 into 87 K5.Found the post: LS 4WD Per LT1, Green pin 16 is used if using the VSS from the transfer case. Otherwise, remove. That's what I did...
