Camar068's latest activity
-
If you have the speed sensor before the transfer case there will have to be some way to tell the speedo it’s in low vs high range to... -
Camar068 replied to the thread 04 LM7 into 87 K5.I think if you put the reluctor on the transmission output shaft, you don't have to have the "4LO" signal to the ecm. I don't use 4LO...
-
Camar068 replied to the thread 04 LM7 into 87 K5.yes you can use a pass-through adapter that will give the signal and still use the cable driven speedo. I put a reluctor wheel on the...
-
Camar068 replied to the thread Gear Ratio.wow.....why so high?
-
Camar068 replied to the thread What radiator are you using for the 5.3.Using stock 86 k10 rad with a fitting soldered in for the steam vent line a few inches below the cap. Windstar, TYC 620270, fan for...
-
Camar068 replied to the thread What new tools have you got lately?.Just like my hunting/skinning knives....you'll never lose it :)
-
I’ve had a large set that my dad got for me from Craftsman about 25 years ago. Maybe less, maybe more, but they’ve always been helpful...
-
Camar068 replied to the thread What new tools have you got lately?.Never knew self adjusting channel locks existed. Gonna get a set. Any Cons to them? Husky Self Adjusting Channel Locks
-
-
Camar068 reacted to 82sbshortbed's post in the thread What have you done to your square lately?? with
Like.
Got it unpacked. She's a beut! New and shinny. That winter last long but hey looks great now. And super pleased with the carb. Bit high... -
Camar068 replied to the thread Faulty rigged.Agree, if your going to use that type of filter, it needs to be up by the carb where you can see it easily....and you be under the hood...
-
Camar068 replied to the thread Remove 4L60E.In regards to the firewall, put a rolling hydraulic jack with a piece of wood under the trans with the wheels turned forward on the...
-
Camar068 replied to the thread Advice on Transmission Fluid Change for 1980 C10.Dex III is the same as Dex/Merc from what I've read.
-
Camar068 reacted to rusted nuts's post in the thread New to the forum and to square bodies wiper question with Like.
Never had it happen but would look for bad ground 1st then bad switch. I always look for cheap stuff 1st, Plus most odd ball electric...
-
Camar068 replied to the thread Engine & transmission removal & reinstall general tips.I would pull the engine/trans together. I've used my lift to pull the engine/trans/transfercase all at once too many times. If in...
-
Camar068 replied to the thread Tires & Rims Reccomendations.I put coil over shocks (to help level the rake) on the front of my k10 and 32's filled the gap for me. Put the same brand coil overs on...
