CalSgt's latest activity
-
CCalSgt reacted to NickTransmissions's post in the thread please recommend a transmission dipstick that isn’t junk. with
Like.
Go to the junkard and buy a good used OEM one out of a TH350 for $5-$10. -
CMy truck has one tank so I think I should be ok
-
C^thats how I fill my Corvair.
-
CI've always read about that online but never think to try it when I'm at the pump
-
CCalSgt replied to the thread 1985 C20: Carb not getting fuel.Any time my carb lost its prime I would need to pour fuel straight into it to get it started. After a start it would stay primed. Also...
-
CFill the float bowl with fuel. Try and start it. With the float bowl full, it should run long enough to pull fuel from the tank. If not...
-
CCalSgt replied to the thread AC system recommendations.I cant speak to the daily operation of the vintage air system because my truck is still not finished but the install was straight forward
-
CCalSgt replied to the thread Do I even need a gas tank vent tube?.Once upon a time when I worked at a Full Service gas station, many of the squares (and a few others) we would flip the hose nozzle...
-
C$221.00 from Summit for manifold back dual kit Just pick your offset in/out mufflers. But a nice single exhaust isn't bad either...
-
CIn high school, I had a ‘76 Nova with a 305 2 bbl. Right after my dad and I got it on the road and I started driving it, the single...
-
CWell , 52 year old Grit dog decided that 10 year old grit dogs favorite exhaust was the quick and easy answer. Side pipes ftw!
-
C4 speed would hold up I'm sure, but most likely not what you want. Your only option really is a t56. You're not going to get what you...
-
CCalSgt replied to the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC.Great write up! I went through this when I did the L31 for the Squircle. Getting them apart with the oil varnish groove is a PIA, but...
-
CCalSgt reacted to RanchWelder's post in the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC with Like.
When it's time to re-assemble each clean dry piston, spring, plunger and stainless cap, make use of a hex nut driver, so you can squeeze...
