CalSgt's latest activity
-
CCalSgt replied to the thread Engine & transmission removal & reinstall general tips.^^^ I’m a fan of the accessory bolts in the heads and a chain
-
CCalSgt reacted to tsgs84's post in the thread Engine & transmission removal & reinstall general tips with
Like.
I always use a front head accessory bolt and a rear head accessory bolt on the opposite side with an adjustable load leveler attached to... -
CCalSgt reacted to Keith Seymore's post in the thread FB Marketplace find near Austin, Texas: 5 aluminum K10 wheels $50 with Like.
I see my work here is done. It was changed as a cost savings. Forged = RPO PH7 Cast = RPO N90 I think the forged wheel will be...
-
CCalSgt reacted to ali_c20's post in the thread New wiring dosnt do anything when key is on. with Like.
I vote for ground. Have you temporary grounded your exterior lights to the chassis/ body ? Ground connection from chassis/body to...
-
CCalSgt replied to the thread Diesel Dash Light and Socket.CA is pretty messed up but at least “smog” is sellers responsibility…. MIL = failed smog
-
CYou holding that lens reminds me of a customer fail inspection due to no MIL on KOEO. Hooked scanner up & there were plenty of DTC's...
-
CThats the one. I have a plan B and C if I dont come up with one.....just wunnerin if one was floating around out there.
-
CCalSgt replied to the thread Diesel Dash Light and Socket.I dug this one up today let me know if the other one falls through. I don’t have the bulb sockets though
-
-
CSend me your address in a DM & I'll get it to you. I have an extra couple. HS
-
CLiterally only 23k miles? Let’s see some pics of that beauty… How do you know they’re stock, you mean they’re 235-75-15s I presume...
-
CI agree. You can't beat rally rims with beauty rings. Also I like stock white steel rims with dog dish hub caps
-
CCalSgt replied to the thread Diesel Dash Light and Socket.Hnmmm… I can’t remember if I still have it… I had a gauge assembly and bezel from a diesel suburban laying around. Not sure if it...
-
CHow hard is it to switch the wiring up to work with the newer 6-port? Can't be that complicated. I'm running dual tanks with in-tank...
-
CCalSgt replied to the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work?.Good choice... @SquareRoot and @nvrenuf give solid advice
-
CCalSgt reacted to Spider's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with Like.
Upon further review, we are pulling the motor mounts and installing correctly. Still don’t know what the small braces are for. Was...
