CalSgt's latest activity
-
CSend me your address in a DM & I'll get it to you. I have an extra couple. HS
-
CLiterally only 23k miles? Let’s see some pics of that beauty… How do you know they’re stock, you mean they’re 235-75-15s I presume...
-
CI agree. You can't beat rally rims with beauty rings. Also I like stock white steel rims with dog dish hub caps
-
CCalSgt replied to the thread Diesel Dash Light and Socket.Hnmmm… I can’t remember if I still have it… I had a gauge assembly and bezel from a diesel suburban laying around. Not sure if it...
-
CHow hard is it to switch the wiring up to work with the newer 6-port? Can't be that complicated. I'm running dual tanks with in-tank...
-
CCalSgt replied to the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work?.Good choice... @SquareRoot and @nvrenuf give solid advice
-
CCalSgt reacted to Spider's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with
Like.
Upon further review, we are pulling the motor mounts and installing correctly. Still don’t know what the small braces are for. Was... -
CCalSgt reacted to nvrenuf's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with Like.
Jack the motor up and slip the brackets in like they are supposed to be. Those short bars look like a/c compressor braces, there might...
-
CCalSgt reacted to SquareRoot's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with Like.
It would be easier to unbolt the mount, slip them in and do it the way it was intended. You don't have to take the engine out. Those...
-
CCalSgt replied to the thread Lift options and recommendations for a 1980 Jimmy.I would think you will need some trimming to clear 35's with only 4" of lift. I have no experience with them but the Off-Road Design...
-
CThanks for the help. Ended up being the stupidest thing possible, but cheap fix. 10 amp IGN fuse.
-
CCalSgt replied to the thread Starter wiring for LS.Yes… purple wire from bulkhead will trigger the starter solenoid so long as you provide power to the two red wires at the bulkhead...
-
CI used the donor '06 Envoy Denali battery cables/start power wires but for the solenoid/key power wire, I used the original '85 wire...
-
CCalSgt reacted to Doppleganger's post in the thread Differences in dash metal by radio cutout? with Like.
I think 89s would have the 1-1/2 din setup.
-
CIt’s totally possible, just have to buy the pieces and like @CalSgt said, get them mocked up right and holes drilled. Idk if any of the...
