CalSgt's latest activity
-
CI should also add that the wiring on this truck is a massive fire hazard. It was a snow plow trucj owned by a farmer, so wiring is...
-
CCalSgt replied to the thread ANYONE USED VORTEC HIGH SWIRL HEADS ON THEIR GEN-I SBC?.IIRC to run the Vortec heads you would need an intake manifold and because Vortec water pump uses a bypass hose a small hole needs to...
-
CCalSgt replied to the thread Wanting an Upgrade.My truck didn’t come with a headliner or trim. I bought the LMC headliner “kit” and the headliner itself wasn’t bad but the rest of the...
-
CWell y’all, been laying rather low with just minor things popping up on E’s square. I go out of town and come home to this! He bought...
-
CCalSgt replied to the thread 04 LM7 into 87 K5.There’s a few circuits in the cab hot while cranking, under the hood I think the coil wire should be hot on run and start. Get your test...
-
CAny wire with a crimp on connector is not factory, such as the yellow wire near the flasher. Not saying that is all bad just trace it...
-
CCalSgt replied to the thread Long Time Lurker and Finally Introducing Myself.Welcome from California, Advice? It sounds like you laid a solid plan by saying you will salvage what you can then replace what you...
-
CCalSgt replied to the thread Accidentally bought a shortbox square body.Welcome from California
-
CIt passed!
-
CCalSgt replied to the thread A/C Question.I'm with Rick on this one... Unless you are prepared to do a complete overhaul of the system at the same time as the engine, just leave...
-
CAt this stage of the game and not knowing the charge status,what works,etc. I'd unbolt the compressor. Bungee it to one side, pull my...
-
CCalSgt reacted to JayRoux's post in the thread Need help finding out where this goes and what it does? with
Like.
-
CCalSgt replied to the thread Vapor canister line.My canisters are labeled next to each fitting, carb, PCV, or fuel tank
-
CCalSgt replied to the thread Where does this dash part go?.Damnit dude… you beat me to it again
-
CIf it's what I'm thinking it should be the braces here to the brake pedal box support.
