bucket's latest activity
-
bucket reacted to CalSgt's post in the thread Best header back exhaust package for a 1985 K10 short bed with
Like.
IIRC the difference between a LB or SB kit is the length of the first straight section as it leaves the mufflers. Many kits just require... -
bucket replied to the thread A very expensive and dumb mistake (update I was wrong).It kinda seemed like the entire pumpkin might be shifted over a bit? I dunno, I guess I've never paid much attention to how much of a...
-
bucket reacted to nvrenuf's post in the thread A very expensive and dumb mistake (update I was wrong) with Like.
All 14 bolts are offset like that and are in literally millions of squares. Don’t sweat it and run it. Just to say it out loud, since...
-
bucket reacted to CalSgt's post in the thread A very expensive and dumb mistake (update I was wrong) with Like.
So long as the angle at one joint matches the angle at the other it’s all good! No different than the downward angle from the trans to...
-
bucket replied to the thread How to ID 16" 8 bolt wheels?.I wouldn't say nobody.
-
Yes those are GMT 400/OBS 8 lug wheels. I have a set of my crew cab. They use a stainless steel trim ring and a plastic center cap...
-
bucket replied to the thread 454 engine rebuild and intake gasket leak.Typically with used heads and/or intake, it's best to smear a very thin coating of rtv around the coolant ports, to prevent minor leaks...
-
bucket replied to the thread What have you done to your square lately??.I'm not sure what's going on here, but that's an impressive collection of carburetors.
-
I'm just gonna post this pic here, promise I'll explain later ETA:
-
bucket replied to the thread A very expensive and dumb mistake (update I was wrong).Why not just try running it? I can't think of what they were off hand, but I know there have been factory built trucks with an offset...
-
bucket replied to the thread What is this gauge?.Oh that's cool! Like a 70's Cadillac! I'd guess it was a part that was available over the dealer counter.
-
Hi again!! What is this? I thought it might be a temperature gauge for outside? Thanks !!
-
Agree
-
Looks good from over here.
-
All right brain trust, is this beefy enough? This took a bit of planning but it turned out how I wanted, unless it's not solid enough...
