boloboss's latest activity
-
boloboss replied to the thread CARBURETOR DATED.Ok -
boloboss replied to the thread CARBURETOR DATED.My timing was initially set at 4° and I turned the distributor just a smidge it to advance it
-
I dont think anyones mentioned this yet.... Whats your ignition timing set at?
-
Yes but the Edelbrock fits on the gm square bore manifold. The AVS2 is spread bore. Adapters are available too. An insulator spacer...
-
Quadrajet by Rochester https://en.wikipedia.org/wiki/Quadrajet Wait a minute, Quadrajunks are spread bores, Them 1400 Eldies be square...
-
boloboss replied to the thread STEERING COLUMN.1st image is area of screeching noise 2nd of column looseness
-
-
boloboss replied to the thread CARBURETOR DATED.Q- Jet by...??? @Snoots
-
Replace it with a Q-Jet or rebuild it while making certain your rebuild kit can handle ethanol fuel.
-
What's up guys? I have a 18 -year-old 1406 Edelbrock carburetor that's been rebuilt twice. Ot stars right up in the morning, no...
-
What's up guys, ...when I turn my steering wheel to the right I'm hearing a screeching sound. It's not coming from none of the front...
-
I run the same carburetor you have. If you are slightly mechanical inclined. Take the number off the bottom left if looking at it...
-
Gotta pump ‘er once to set the choke….
-
Nobody mentioned the fact that the choke on an Edelbrock (and many other carbs) will stay in the 'warm engine' position (choke plate...
-
For starters, all of the seals and gaskets in that carb (if it hasn't been re-built lately) are shot from both age and ethenol fuel. If...
-
What's up guys??? ... regarding my question earlier .... why after I start my truck and it gets warm, then I drive, cut it off, and it...
