animal's latest activity
-
With your press woes, some extreme pressure grease goes a long way on making press fits smooth, mitigates galling, etc. something like... -
So last night I decided to shimmy the carrier over to the pass side a touch more to tighten up my backlash. Remember spec is .006-.010...
-
animal replied to the thread Howdy- 1st Post.:welcome:
-
So now it's time to remove bearings. This is the tool Spencer (@legopnuematic ) suggested I pick up and I'm so glad he did. This is so...
-
Driver's side race had not fallen out yet so it came with the adjuster Pass side race had fallen out earlier just by me setting...
-
Couldn't hold everything and take a picture but using a straight edge got me much more reliable measurements than off the case openings...
-
Maybe cuz the front diff isn't always spinning so the bearings dry out and it's rough on them the first few seconds of engagement? Or...
-
Backside of the vent Everything looks pretty clean inside considering the schmutz we saw earlier Then took out the 15mm bolts...
-
This is all that actuates the front axle. A little shift fork and collar. Pass side/long side adjuster Driver's side/short...
-
Didn't get any shots mid-pull cuz it was sketchy AF trying to get that thing to balance on the transmission jack while it also rolls off...
-
So then I popped out the drain plug to let it start draining while I pulled the CV axle bolts out Fluid looked pretty good but there...
-
So then yesterday I came up to the shop to work on the front diff since my new bearings from QP didn't show up Saturday like I'd hoped...
-
Ok, so I made a couple adjustments last Friday and forgot to post them. Took .005" off the pinion shim and shifted the carrier to the...
