ali_c20's latest activity
-
Correct. Hole for body trim. The holes eventually went away because they were a spot where rust could originate. K -
Why not? Would have been that "stainless" style trim I believe. My 84 burb has the same hole on the front fender, before and after the...
-
ali_c20 replied to the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ?.The ends were the same.
-
I think I ran into the same issue as you using the LMC three point belts. The hardware they send with the retainer was much smaller...
-
ali_c20 replied to the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ?.When I did the swap 203 to 205 on my K5 I had to have the front driveshaft shortened and the rear lengthened. I have a TH350 and GM...
-
ali_c20 replied to the thread Exhaust collectors for manifolds.I cut off the material below flange on the manifolds of my K5 to have a flat sealing surface. I used a fat flange with a flat gasket...
-
Thank you so much ! Finally got some good information, I found the Motor and the linkage at LMC I owe you!!!
-
ali_c20 replied to the thread Mystery hole on fenders.Hm, the position would match with the side trim. Maybe the original trim was adhesive and retainers at the ends that were prone to get...
-
ali_c20 replied to the thread New project owner.Welcome from Austria. Great project.
-
On January 17, 2025, my 1987 Chevy Silverado SWB was stolen, 12 noon, right out of the parking lot of the government building where I...
-
Things turned out so that the Anchors were not available. The cracked rear mount convinced me not to buy far east rubber, so I Installed...
-
ali_c20 reacted to QTR83's post in the thread Who said you need 4X4 to drive in desert, when you have a SquareBody? with
Like.
Over the weekend I decided to test my car in the sand and I was very impressed with its performance even though it is only rear wheel... -
You could have replaced the column detect to get the shift indicator working right. But no light source without the original cluster
-
ali_c20 replied to the thread Wiper motor Assy 74 C10.The early style wiper motors are rare. You can use the 78 - 84 wiper motor with pump. You need the wiper motor arm and the matching...
-
Thanks all, I'm going this weekend to look at a donor truck. Mine, quite frankly, does not have much body left at all so it'll probably...
