ali_c20's latest activity
-
I would search the classifieds, CL, FB etc and if you find a good bed nearby, don’t hesitate. Original beds have 2 things against them... -
ali_c20 replied to the thread Replacing Long bed.Welcome from Austria. You should be able to find bed parts on junkyards if you have a lot of time for searching. Or get the AMD parts...
-
Hey all, I've recently purchased my long term project truck. It's a '79 K10 Silverado with a long bed. The bed is pretty well gone...
-
Put a tach in it,see what kind of rpms you are actually turning at 70mph As to what gears or what transmission. That depends on what you...
-
They are probably 4.56 gears. 4.10s were also common in the 3/4 tons with the same axle, so a swap should be easy, and you may be...
-
Here's a couple good videos from my buddy, Jason
-
I ended up installing Dakota Digital GSS-3000 Universal Sender Unit for Gear Shift Position Indicator. The column gear selector would...
-
Yes, I have a total of 7 shift points on my column. I can shift into every gear with the column. I switched out the gear selector...
-
ali_c20 replied to the thread Hello everybody!!!.Buon giorno. Benvenuto dall'Austria.
-
Hello everybody, I am Max from Italy. I have a 1976 K20, 350 Vi 5.7l that I am trying to restore. It an honor for me to be part of this...
-
ali_c20 reacted to projo198's post in the thread Very nice bezels from Holley website for cheap with
Like.
Waited u til I installed it to make a recommendation. They have ac and non-ac bezels for around 40 bucks. If you search the part number... -
Never thought I’d go electric 1,300 miles
-
nice little pile of dirt over there... prob coulda got higher but foiled by the hitch...
-
ok, maybe these v6's won't be too bad for dailys.....
-
ali_c20 replied to the thread Hello from Northern MA!.Welcome from Austria. Great story and cool truck.
