ali_c20's latest activity
-
Rebuilt the rear brakes completely and put on the wheels. -
If you’re going through the process of blasting it clean to bare steel, you don’t want rust reformer type coating, you want paint...
-
Can’t wait to see a truck on that frame someday! You make some good points. 1 being, powder coat isn’t any better. It won’t get into...
-
ali_c20 replied to the thread Eastwood Versus POR15.I painted the frames of my K5 and C20 after blasting with a quality primer and 2k chassis paint from the same company. I applied it...
-
If you’re blasting you shouldn’t need any special “prep” product, paint will stick to the rough texture left from blasting. I don’t...
-
time to go wheeling tonite....
-
I want my 1973 K5 blazer to be a daily driver. I am having new gears put in it so it's more drivable. The 3.07 ratio were way too tall...
-
ali_c20 replied to the thread Drop pittman arm or raised steering arm or both.Welcome from Austria. Get a raised steering arm that is made for 6 inches lift. Buy new hardware too.
-
ali_c20 replied to the thread 1986 New member in Az.Welcome from Austria. Nice project truck.
-
Thanks! Runs good! I guess it has a 2bbl quadrajet. May need to lean it out since I’m at 7k ft altitude. Small things to fix, hood rubs...
-
Bought it for 5k! Drove home 80 miles on interstate. Did great except vibration from front. Hubs are unlocked and it’s in 2WD but...
-
Like me others have had very bad experiences with USA1, never again.
-
ali_c20 replied to the thread Fuel Valve Replaced.Have replaced all hoses too?
-
First thing that comes to mind is dirt. Check fuel filter, pump pressure and volume.
-
I have two sets. First are the 16.5s shown below. These are a matching set of four with 33x12x16.5s vortrax radial tires. Two tires...
Latest posts
-
-
-
Removing instrument panel - dealing with the oil pressure line- Latest: PrairieDrifter
-
-
