Recent content by 87gmcburb
-
I hate the power window and door lock switches
Just looking at Summit again and I found these that might work great for a 2 door and kick the switches out at an angle instead of being flat againsyt the door panel. The cost is not bad but do not know any other specs on them. Just a thought for you but would need to cut the OEM connector off... -
I hate the power window and door lock switches
In my opinion, Autolocs are great for retrofitting manual crank type to electric in order to keep the crank style look with electric windows. As stated by others, these OEM switches and the connector is trash. I have been taking a serious look at these billet switched from Summit. Upside, they... -
-
Which headers to buy?
There are so many out there, the flow tech listed above in the link are good from what I hear. It all depends on what you want to spend. The best ones I ever had were Doug Thorley Tri Y's but they cost a lot more than the flow tech headers.- 87gmcburb
- Post #5
- Forum: Engine & Performance
-
edelbrock avs2 650
I just converted my 87 from TBI to carb and using the same carb (AVS2) at 4 psi with an air gap manifold. I have used basically the same set up on my last few burbs as well and even warm I still give it a pump or 2 when re-starting. Just the nature of a carb vs TBI. As stated above, dial in your...- 87gmcburb
- Post #27
- Forum: Carb Fuel Systems
-
Color blind! Burgundy or Maroon?
You should have the GM color code on your tag in the glove box. Yes it looks Burgundy, the code should be 77D for an '87 -
Trim codes 77B and 77I
It looks like you have the exact color package as my 87 burb. You have 77D interior which is Burgundy and 72U exterior which is 72 apple red (I have 90 Steel as the 2 tone lower color). Many time you can find the color marked on the backside of the velour door panel insert or even the backside... -
Let’s see your memorabilia?!
Its still works but I have a drop down LED to watch the actual games and such -
-
Let’s see your memorabilia?!
notice the Terry Bradshaw peanut butter from the late 70's on the right hand side :) -
Let’s see your memorabilia?!
Ok, I know this is not mechanical or car related but it is in my garage :) Its not all of it but here is a sample. The 8x10 photos and mini helmets are autographed. -
Just Because....
- 87gmcburb
- Post #2
- Forum: Other Vehicles
-
Just Because....
- 87gmcburb
- Thread
- Replies: 2
- Forum: Other Vehicles
-
Hello from Indiana!
Welcome, Washington Indiana, here! Nice SB- 87gmcburb
- Post #21
- Forum: Introduction
-
Door Seal to big
The seals from LMC, Classic etc... are all aftermarket and fit poorly. If you are looking for actual OEM fit you need to contact Mr A' Chevy truck parts. HIs name is Jon Addington and he is the only place I have ever found actual OEM fit. He uses NOS seals and has them reproduced, this is as...
