84_c10_GMC's latest activity
-
884_c10_GMC reacted to ChuckN's post in the thread Fuel gauge to tachometer, clock to fuel gauge with
Like.
You’re likely onto something there- I’m a little rusty since I did mine probably a couple years ago. -
884_c10_GMC reacted to Ricko1966's post in the thread Hard starting after sitting for a few days with Like.
Hmm,have you checked to make sure the choke is fully closing cold,next time you go to start it when it should be acting up,take off the...
-
884_c10_GMC replied to the thread Fuel gauge to tachometer, clock to fuel gauge.The summit tach is 3 wires off back of the guage. Ground power and signal wire. Other post on here used an inline fuse that plugged...
-
-
884_c10_GMC replied to the thread Fuel gauge to tachometer, clock to fuel gauge.I haven’t seen any small oem style. But I believe Holley/brothers had some that will fit in the oem guage holes.
-
884_c10_GMC reacted to jh86's post in the thread Fuel gauge to tachometer, clock to fuel gauge with Like.
In a different approach, anyone aware of a small matching tach that goes in an empty small gauge location I have?
-
884_c10_GMC replied to the thread Fuel gauge to tachometer, clock to fuel gauge.Thanks for the info. I was gonna go the route of pinning on the main gauge panel plug to get the wires to the new fuel gauge. And then...
-
884_c10_GMC posted the thread Fuel gauge to tachometer, clock to fuel gauge in Gauge, Speedo & Instrumentation.hello, Has anyone used the summit retro gauges to replace their square body gauges? I am looking at replacing my large fuel gauge...
-
-
8Ok i now retract my above statement lol
-
8Since this virus has been around I been working non stop on my truck. Just got done doing a new cam, gear drive, new exhaust, new dizzy...
-
884_c10_GMC reacted to 75BEASTK20's post in the thread K20 upgrades. EDELBROCK AVS II. Why so negative ? with Like.
Glad we're going down in the new truck. Winter tires. Winter ready.
-
884_c10_GMC replied to the thread K20 upgrades. EDELBROCK AVS II. Why so negative ?.You better get to moving. Eastern Kansas has rain and cold weather coming this weekend. Single digit lows coming
-
884_c10_GMC replied to the thread 1982 c10 drive shaft length.That doorman that measures 75” how are they measuring that? I have an 84 c10 with the 6” th350 I need a shaft for and I’m measuring u...
-
8I use inline tube. They have everything you need factory bent. I actually have a set of front brake lines for my 84 Sierra C2500 that I...
-
884_c10_GMC reacted to ChuckN's post in the thread Long tube headers/dual exhaust question with Like.
I thought I remembered Engine Masters doing an episode on this stuff, if the performance aspect matters to ya.
