-
-
NickTransmissions replied to the thread Which 4L80 for my swap.1999-2000 are optimal, IMO. 1997-98 are good; 2001+ are also fine but 1999-2000 had both the wider coast band (intro'ed in 1999) and... -
Thanks! Flushed it today and no debris!
-
NickTransmissions replied to the thread Rebuild th400 or 4l80e?.I personally have not had experience with those particular coolers but if you do buy one, I'd blow shop air through it to see if there's...
-
NickTransmissions replied to the thread 700R4 Information Thread.I don't but maybe others on here do...You can also contact Dana Wilkes at Probuilt Automatics to see if he knows or the folks at...
-
NickTransmissions replied to the thread My 700r4 changes too early ?.You need to provide more information about your truck's set up as well as what has already been done to the governor, if anything. Is...
-
NickTransmissions replied to the thread Passing gear cable.Bad geometry results in poor line rise which will lead to 3-4 clutch and/or 2-4 band failure...Here's some instructions to help you with...
-
NickTransmissions replied to the thread How many bolts hold the transmission on and where?.Then you don't have a flywheel, you have a flex plate...They are not the same nor can the terms be used interchangeably...Just FYI if...
-
NickTransmissions replied to the thread How many bolts hold the transmission on and where?.Do you have an auto trans or a manual?
-
NickTransmissions replied to the thread How many bolts hold the transmission on and where?.Not really. It's much easier to simply remove the trans, get it out of the way so the flexplate can be removed and new one installed...
-
NickTransmissions replied to the thread Rebuild th400 or 4l80e?.Your new aluminum 2-3 acc piston is threaded? I've never encountered that before. It should have a smooth bore. You can use a press or...
-
NickTransmissions replied to the thread Th400 Torque Converter Shaft Seal.Since you will have the pump open, do the following checks: - Inspect the pump body working surface for scoring, unusual wear, etc -...
-
NickTransmissions reacted to perky's post in the thread Th400 Torque Converter Shaft Seal with
Like.
Read up on the bushing and figuring I'll replace it as long as the trans is out, because it seems to be a common source of leaks on... -
NickTransmissions replied to the thread Th400 Torque Converter Shaft Seal.You're welcome...I should clarify my above to say the pump would have to come out and apart so you can replace the bushing, if worn as...
-
NickTransmissions replied to the thread Th400 Torque Converter Shaft Seal.Check the pump bushing once you have the front seal off. If it's excessively worn, trans would have to come out so it can be replaced.
-
NickTransmissions replied to the thread 350turbo out 700r4 in expected cost?.2WD or 4X4? Also, are you doing the physical swap or outsourcing it? Figure $150-300 for a cut/balance of the driveline by a driveshaft...
-
-
Loading…
-
Loading…
