-
-
CCountKrunk reacted to Ricko1966's post in the thread Project is stalled. Cannot solve brake problem with
Like.
There is a hole in the master cylinder,sometimes there is spacer in that hole also. The brake booster has a pushrod that fits in that... -
CGot a bit of work to do with installing guides (Going from 3/8" O.D. to 11/32") and oversizing the valves (From 2.06" in and 1.72" ex to...
-
CCountKrunk reacted to legopnuematic's post in the thread 2005 Ram 2500 Free Spin Install & Other Goodies with Like.
Went to install the knuckle U joints, first one on the long axle shaft was fine, short (drivers side) shaft could get one ring in...
-
CCountKrunk reacted to legopnuematic's post in the thread 2005 Ram 2500 Free Spin Install & Other Goodies with Like.
Installed the new axle shaft seals, and clean of the inside of the housing. New ball joints. Canada Eh. Pressed in.
-
CCountKrunk reacted to legopnuematic's post in the thread 2005 Ram 2500 Free Spin Install & Other Goodies with Like.
Shane had decided to go with a new carrier, also new bearings and ring gear bolts. Will be transferring the spiders over. Some cast...
-
CCountKrunk reacted to legopnuematic's post in the thread 2005 Ram 2500 Free Spin Install & Other Goodies with Like.
Finally was able to make it back up to the shop Friday after work. Between the snow and me being under the weather, waiting for parts...
-
CCountKrunk reacted to Chris64's post in the thread First real drive! Not tragic but not good. I think I need carb advice. with Like.
I'm going to keep responding to myself with the answers to my own questions in case any other SB noobs run across this. Answers for...
-
CCountKrunk reacted to Ricko1966's post in the thread 2.73:1 Rear - Do I have a chance in hell to...... with Haha.
Ohh now you've done it.!!!!
-
CCountKrunk replied to the thread 2.73:1 Rear - Do I have a chance in hell to.......That plus a junkyard quadrajet will get it done
-
CCountKrunk reacted to jh86's post in the thread 2.73:1 Rear - Do I have a chance in hell to...... with Haha.
I think all this discussion settled it, 16” tires are the way to go.
-
CYeah well… I’ll call him and let him know but he was heading out of town on an urgent family thing. I know for a fact he didn’t cause...
-
CPicked up the truck today as the shop couldn’t reproduce the starting issue. It started for them every time… probably 20-30 times over...
-
CAnd done. So much for getting this done before the snow/ice hits tomorrow. Guess I'm driving the C10 home tonight and staying put for...
-
CI'm guessing it's a setting in your phone. But, I have found in the past, that occasionally a downloaded picture from somewhere else...
-
CCountKrunk replied to the thread Bad Key Cylinder?.To add an experience my truck after driving a while, turn off. Go to turn back on 10 min later. Nothing, completely dead. Banged on the...
-
-
Loading…
-
Loading…
