-
-
RanchWelder replied to the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft.It's rewarding to see the plan coming together. -
RanchWelder replied to the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft.If they are not ruined, you might try to weld and ream then use new grade 8 washers. The inner tubing for OEM bushings has a "crown" on...
-
RanchWelder replied to the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft.Suggestions on a shade tree alignment process would be apreciated. The rear 14-Bolt is narrower than the front, same as the Corporate...
-
I reused a set of decent u bolts once, had to swap the axle used the u bolt again, may have slightly over torqued it but barely. Snapped...
-
A lot of people view ubolts as a 1 time use part. That said, I’ve reused a lot of them and I’ll be reusing my current rear ubolts when...
-
Yes. They should be torqued only one time. They stretch for clamping force.
-
Some fasteners need to be torqued. Some fasteners need to be as tight as you can reasonably get them. A big bolt on a leaf spring...
-
RanchWelder replied to the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft.Here's a pic of the rear end and springs, without transmission or drive line in the way: Here's the underside of the fifth wheel...
-
-
RanchWelder replied to the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft.Wheels are just off the ground, on jackstands. All the hubs, brakes and joints are new except the drag link ends. The front sway bar...
-
-
RanchWelder posted the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft in Suspension, Steering & Brakes.My 14-Bolt rear suspension included Leaves being swapped from 52-inch stock springs to 60-inch stock springs. Added extra long perches...
-
-
RanchWelder reacted to Snoots's post in the thread battery junction Block issue ( see photos) with
Like.
-
RanchWelder replied to the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC.From what I'm reading on several other forums, cleaning brand new lifters might save your engine. There's only one way to know if...
-
-
RanchWelder replied to the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC.When it's time to re-assemble each clean dry piston, spring, plunger and stainless cap, make use of a hex nut driver, so you can squeeze...
-
-
RanchWelder posted the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC in Engine & Performance.Cleaning your roller lifters can go a long way to saving money on a rebuilt Roller Engine. First carefully remove the clips with a pick...
-
-
RanchWelder replied to the thread What have you done to your square lately??.Skyjacker front springs and ORD bushing/shackle kit going in. New steering box, not reman. Tanks US Gear Missourah! Pics to follow...
-
-
Loading…
-
Loading…
