-
-
scrap--metal reacted to 75gmck25's post in the thread Need to replace rubber fuel lines on top of both tanks…. with
Like.
EFI SAEJ30R7 or R9 hose is expensive from the local auto stores, so I have bought sections (10 foot?) online from Amazon. I used the... -
scrap--metal replied to the thread Need to replace rubber fuel lines on top of both tanks…..Sometimes the bolts holding the bed down can be pretty crusted in place. The condition of your truck may dictate which method is easier...
-
scrap--metal reacted to PrairieDrifter's post in the thread Dakota Digital RTX gauge cluster with Like.
Don't be so quick to change everything. A lot of the new stuff we get is just pure junk, can't even get a headlight switch to last with...
-
scrap--metal reacted to Strick's post in the thread Searching for My Dad's 1979 Chevy Suburban with Love.
Grit is even salty... but definitely leaning on the law of averages though. The odds are slim on finding that specific vehicle. BUT...I...
-
scrap--metal reacted to Keith Seymore's post in the thread Searching for My Dad's 1979 Chevy Suburban with Like.
Almost - All square Blazers and Suburbans were built in Flint Michigan. The "F" in the VIN denotes Flint Assembly. Fremont is noted...
-
Don't they have enough wind noise in the cab?
-
scrap--metal reacted to CrazyArk's post in the thread Loss of one of our members, ole mtnmankev with Like.
Took me some time to post this. But in the very early hours, we lost mtnmankev. A brilliant and goofy individual I had known for a...
-
scrap--metal replied to the thread Really tight front brakes!.You should be able to turn the front wheels by hand. There should be some resistance, if you give them a good spin and let them free...
-
You can always LIE about the cubic inches............has been done a LOT in the past.......remember all the CORVETTE engines that...
-
More pictures. Who doesn't love pictures?
-
While shopping for a replacement motor for my son's dentside Ford, I stumbled across a one owner '74 C30 flatbed. I fell in love with...
-
scrap--metal replied to the thread Thread sealant on header bolts?.If your valve covers are beat up with a deformed edge, they'll still leak after replacing the gaskets. Just something to consider.
-
scrap--metal reacted to CountKrunk's post in the thread What will cause this to happen in a 208 Transfer Case (Pic Inside) with Haha.
You're just like FedEx! ;)
-
scrap--metal replied to the thread What will cause this to happen in a 208 Transfer Case (Pic Inside).:popcorn:
-
scrap--metal replied to the thread After installing aftermarket tach the truck will not start.I bet this is it, too.
-
-
Loading…
-
Loading…
