-
-
Strick reacted to Ricko1966's post in the thread Advance adaptor for m-21 to a truck bell housing with
Like.
I'd sand the inside of the adapter and out side of the retainer probably lightly dress the outside of the retainer with a file. Is this... -
You need a real torch like I said. A bottle torch won't cut it.
-
Strick replied to the thread old guy newbie.Welcome from NC & I commend you for fixing a Square for your bride. HS
-
Strick reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
I belive the 2 transmissions are the same. I have a 12inch clutch in the truck right now. Thatd be great if i can use everything that i...
-
Strick reacted to Ricko1966's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
^^^^ use the pressure plate that matches your engine and a clutch disc that matches your transmission,may have to look at a few to pic...
-
Strick reacted to bucket's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Glad to hear from you again! Are you sure you're engine is an '86? '86 was the first year for a 1-piece rear main seal with the smaller...
-
Strick replied to the thread A new comer with a problem.Welcome to the site & finally joining in. I wouldn't hesitate to use a Goodmark or AMD product. I've had great fit from both products...
-
Strick replied to the thread Fair price to switch a V10 front and rear diffs to 373 from 308 gears.I just swapped from 3.08 to 4.56 on my '87. I put Spartans on both ends too & it costed me about $1500 total in parts. That is with me...
-
I used rivet nuts, they make aluminum ones with the steel thread and the brackets that go in the doors can pivot left or right I just...
-
-
Loading…
-
Loading…
