Dmack
Latest activity Postings About
-
-
I'm about to paint mine too, maybe powder coat if I find the perfect color, was thinking like copper or a dark champagne color for my... -
Dmack replied to the thread Rally wheel colors?.I went to a dark metallic Grey on mine for my 70 C10 project.
-
-
Dmack reacted to legopnuematic's post in the thread Project is stalled. Cannot solve brake problem with
Like.
Are the rear drums adjusted correctly? -
Dmack replied to the thread dash gauge bezel mods.I replaced all the smaller factory gauges in mine with some basic 2" oil, volt, temp, and tach gauges. Just opened up the factory holes...
-
Dmack replied to the thread Paul's 1972 Truck....Whenever I hear people talking about 3" exhaust, I think back to my high school days when you had to pay extra to upgrade to the big 2"...
-
Dmack replied to the thread Let’s slay this dragon….Pegged past full means an open circuit. Look for a disconnected, broken, etc wire. You may be able to see the connection on the tank...
-
Dmack replied to the thread New wiring dosnt do anything when key is on..Just remembering, I think the headlight circuit doesn't work like a traditional circuit. Something like it's the ground side that is...
-
Dmack replied to the thread New wiring dosnt do anything when key is on..If it's an aftermarket harness, I would guess that if you have the main power input hooked up to the new fusebox, a good ground, and a...
-
Dmack replied to the thread Advice on Transmission Fluid Change for 1980 C10.TH350, aka turbo 350
-
Dmack replied to the thread Saginaw Steering Gear Rebuild - Special Tools?.Do a search on the forum. When I was resealing mine, I found a few detailed posts. Vince (Vbb199 had a very detailed write up iirc).
-
Dmack reacted to legopnuematic's post in the thread Alt Replacement Options? A bit confused. with Like.
You should be able to swap the pulleys with the one from your old alternator.
-
Dmack replied to the thread brake pedal has no pressure.If you can't see any active leaks, you may have a problem with the master cylinder. Either defective or needs bleeding. Did they ever...
-
Dmack replied to the thread Let’s slay this dragon….Hate to state the obvious, but you will probably just have to start tracing wires to.see where they go. You will probably find one of...
-
Dmack replied to the thread Help with gauge cluster lights.The twist-in bulb holders are replaceable. You can also take a pencil eraser and gently clean the area they contact the printed...
-
I ended up putting in a new switch just to eliminate that possibility. I chose to put in a 1987 switch that isn’t momentary. I also...
-
-
Loading…
-
Loading…
