-
-
Ttenthirtytwo replied to the thread TH400 Direct Drum/Sprag Question.I concur with everything that Nick has already stated. Here's another option for rollerizing the output shaft in the TH400, all in one...
-
Ttenthirtytwo replied to the thread Undertightened cork gasket on TH350 and whole thing flooded, clean and reuse?.IMO, once the cork gasket gets saturated with ATF, it's unusable..
-
Ttenthirtytwo replied to the thread Undertightened cork gasket on TH350 and whole thing flooded, clean and reuse?.The only time that I use a cork gasket is on an overhaul, meaning that everything is bone dry after a rebuild. On a trans service (fluid...
-
Ttenthirtytwo reacted to NickTransmissions's post in the thread Undertightened cork gasket on TH350 and whole thing flooded, clean and reuse? with
Like.
DO NOT USE CORK! A standard composite gasket is fine. Bolt toruque is 13 ft lbs. No RTV, either. If you have to use it, something's wrong. -
Ttenthirtytwo replied to the thread Electric Fan Runs After Shutting Off Engine: Where To Start.Perhaps a chafed/bare ground wire going to ground, causing them to continue to run?
-
TI am sure Hotrod already knows this but for those that dont, Becarefull air testing when the clutch pack is NOT installed. TOO much...
-
-
Loading…
-
Loading…
