tadslc
Latest activity Postings About
-
-
tadslc replied to the thread Gas Gauge Problems Continue.This just isn't normal or close to normal fluctuations. This is like it's tied to the throttle. -
Maybe it just wasn't meant to be, a working gas gauge. I ended up going with a Holley Sniper and replaced the fuel tank with a LMC Fuel...
-
I have access to enough donor vehicles that I can still go with used OE as a first choice. If I lived more urban or didn't have room for...
-
tadslc replied to the thread Printed Circuit Question 79 K10.I bought one of those circuit boards from LMC and was very disappointed in the quality. Typical Chinese junk. After I installed it 1/2...
-
tadslc replied to the thread Want to build a good horsepower, good fuel economy engine for a 1978 c20 with stock 350. I don't know much and need help..I applaud your effort and want to give you some advice. Although I am a total SBC novice I know this has been true for the vehicles I've...
-
Sounds kinda like head gaskets if the smoke is white. I'd pull a plug before you run it anymore and see if the plug is wet
-
tadslc replied to the thread LMC EFI Tank Sender problem.I guess you missed in my post #3 that I had just replaced the gauge and already had tested it to make sure it worked. Oh well...
-
1st time squarebody owner & loving it ! Lots of reading & questions inbound !
-
tadslc replied to the thread Hi from Birmingham !.I'm from the Magic City too... Welcome! :welcome:
-
tadslc replied to the thread LMC EFI Tank Sender problem.You didn't embarrass me in the least RP, you just ticked me off. I was referring to the post from SquareRoot in jest. I did everything...
-
tadslc replied to the thread LMC EFI Tank Sender problem.So you really want to embarrass me? It turned out to be the gauge. And... the reason why I wasn't getting a reading from the senders...
-
tadslc replied to the thread LMC EFI Tank Sender problem.You are quite the bully RP I have done everything you have suggested, several times over. May not have described the tests to your...
-
tadslc replied to the thread LMC EFI Tank Sender problem.There must be some disconnect in the way I am explaining myself. Apologies if you've taken offense. I have repeatedly said I have...
-
tadslc replied to the thread LMC EFI Tank Sender problem.There is no arm on these "floatless" senders. As stated previously, I have already checked both senders with an ohm meter. Both are...
-
tadslc replied to the thread LMC EFI Tank Sender problem.I just tested the original sender in a bucket of water hooked up to an ohm meter and it worked fine. 0 empty and 82 full.
-
-
Loading…
-
Loading…
