spinle lock nuts/ torque specs

[VAL]

Does anybody know what the torque specs are for the front rotor spindle bearings on an 86 k10?

 

[sticman]

Right out of my manual.

You must be registered for see images attach

You must be registered for see images attach

 

[VAL]

THANK YOU!, STICMAN. If your ever down here in AZ, get at me, I'll buy you a whole lot of Cervezas!

 

[Camar068]

Gonna dig this one up. My book says the same, 50lbs-1/4 turn-35lbs-3/8's turn. I've watched 2 video's and neither of them backed off 3/8's of a turn. One backed off 1/8 after 35, the other left it at 35.

I haven't done it yet, but is 3/8's backoff correct or are these video's going on experience?

Hope you don't mind VAL, I'll create another post if you like.