John Wilson
Junior Member
- Joined
- Aug 28, 2017
- Posts
- 2
- Reaction score
- 0
- Location
- Augusta ga
- First Name
- John
- Truck Year
- 1973
- Truck Model
- C10
- Engine Size
- 455
I'm trying to fit 31 by 12 by 15 in slicks on my 73 C10 long bed I need help
Slicks
- Thread starter John Wilson
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
MikeB
Full Access Member
- Joined
- Apr 4, 2014
- Posts
- 1,771
- Reaction score
- 998
- Location
- North Texas
- First Name
- Mike
- Truck Year
- 1969
- Truck Model
- C10
- Engine Size
- 355
Not exactly, but close:
http://www.jegs.com/c/Tire_Drag-Racing-Tires/10579/10002/-1?N=1010579+4294960803+4294938430&Ns=P_PrimarySecondary|0||P_SalesVolume|1&Tab=SKU
Edit: Sorry, but I initially read "...trying to find..."
http://www.jegs.com/c/Tire_Drag-Racing-Tires/10579/10002/-1?N=1010579+4294960803+4294938430&Ns=P_PrimarySecondary|0||P_SalesVolume|1&Tab=SKU
Edit: Sorry, but I initially read "...trying to find..."
Last edited:
gpmorgan
Full Access Member
- Joined
- Nov 9, 2013
- Posts
- 562
- Reaction score
- 105
- Location
- Tupelo Ms.
- First Name
- greg
- Truck Year
- 1992
- Truck Model
- 1500
- Engine Size
- 632
What's the issue.
John Wilson
Junior Member
- Joined
- Aug 28, 2017
- Posts
- 2
- Reaction score
- 0
- Location
- Augusta ga
- First Name
- John
- Truck Year
- 1973
- Truck Model
- C10
- Engine Size
- 455
I'm not sure what back spacing I need and if it will fit in the tubs
cooperhw
Full Access Member
- Joined
- May 31, 2017
- Posts
- 390
- Reaction score
- 226
- Location
- Mesa AZ
- First Name
- Wayne
- Truck Year
- 1978, 1981, 1983
- Truck Model
- C-10, K-20, C-20
- Engine Size
- 5.7L
Get a flat piece of 1/4 X 1" X24" long mild steel at Home Depot or wherever. Drill two holes of the end so it bolts onto your lugs. At the far end drill a hole 3/8". in this hole put a 12" piece of all thread with a washer and nut on each side. You can adjust the all thread in or out to see exactly how much clearance you have going towards the inside (offset) or outside towards the inner bedside. poor boys way to buy wheels/tires once. Attach the bar on top of the drums and rotate around adjusting it as you go to maintain about 1 inch clearance. Check both sides cause they will probably not be the same. See what works on your truck.
Similar threads
